What’s the Right Power Amp Ratio For Bi-Amping?


Is there a “golden rule” or rule of thumb when selecting amplifier power in a bi-amp setup? It seems to me that the power should be apportioned according to the demands. Since most of the energy consumption  in sound reproduction is by lows, it stands to reason I should use a much more powerful amplifier for lows than highs, but what ratio of power? 2:1? 10:1? Is there a wrong answer?
128x128sleepwalker65
A rule of thumb I’ve seen stated, which seems to me to make sense as a very rough approximation, is that music tends to require similar amounts of power at frequencies above and below 350 Hz. That should be considered in the context of the crossover point of the particular speaker, as bdp24 alluded to in his post. So if the crossover point of the speaker is considerably lower than that figure the high frequency amp will probably have to supply more power than the low frequency amp much of the time, and if the crossover point of the speaker is considerably higher than that figure the converse would be true.

The upshot is that the mid/high frequency side will have an impedance to frequency curve that presents no load to the amplifier below the crossover point.
That is an oversimplification, of course, as you probably realize. Below the crossover point the load impedance presented by the speaker to the high frequency amp will gradually increase as frequency decreases, at a rate roughly corresponding to the slope of the crossover network (e.g., 6 or 12 or 18 db/octave).

Also, Erik makes a good point about the fact that if the two amps are properly gain matched, and a passive biamp configuration is being used (i.e., there is not an electronic crossover "ahead" of the amps), both amps will have to output voltages corresponding to the full frequency range of the signal. As a practical matter what that usually means is that in a passive biamp configuration there should not be a huge disparity between the power capabilities of the two amps. Otherwise the power capability of the low frequency amp that can be utilized, without driving the high frequency amp into clipping, may be limited by the voltage swing capability of the high frequency amp.

Regards,
-- Al
The amps should be the same , and using an active crossover .   Without a crossover , you would want amps with output trim.  I agree with the one good amp rather than 2 lesser or different amps.  Personally I think bi amping is a waste.
Al, thanks for your insight. As always it gets the mind looking at different angles. The theory I’m going on with significant differences in power requirements is that low frequencies have longer wavelengths and the woofer cone has a much larger  surface area driven to much greater excursions. The effect is moving significantly greater volumes of air. I theorize that the power to drive a 10” woofer over an excursion of 0.5” must be an order or two of magnitude greater than the power to drive a 3/4” soft dome tweeter 1/100”. 
Hi all, Here's something to think about. If you have two identical amps you will have the option to vertically bi-amp as well as horizontally as you guy's are discussing. I don't know the advantages of each way, maybe ALMARG will chime in.Tish