Room Correction: Should I disconnect my REL Subwoofers before running room correction?

I would think you would leave them connected.  You want to measure the room with all the components you are using.

depends of the subs can have their levels adjusted by the dirac bearing unit appropriately

Room Correction: Should I disconnect my REL Subwoofers before running room correction?

Not if it’s being correct as well with your mains. leave the xover on it up full and the level at 1/2 and the room correction should take care of the rest, even the phase if it’s a good one that uses a microphone when doing it's FR sweeps.

Cheers George

@George.  To clarify : So when running the RC, I would set the sub volume at 50% and the frequency at 100%? If I am understanding that, would I then leave the sub at those levels when playing music? 

Subs are the most important part of room correction. :)  Leave them on.

Did you buy the full version of Dirac live or are you running the  free version that comes with the NAD? The free version only goes from 20hz - 500hz so I would leave the subs on,  doesn't the instructions tell you how to set the subwoofer? 

I bought it second hand and downloaded the app.   I ran it a number of months ago and looks plug and play.  I think it ask if you have subs during set up but not subs integrated with mains as in the case of the Rels. I think I must have selected “no subs”.  So the A.I. basically thinks those are my mains.  

I would run it again from the beginning when it asks about subs say yes it assumes you’re integrating them with either small or large main speakers. You might have to adjust the sub volume on the sub or it might allow it in the software but it should have a volume bar in the RC and you will need to adjust until it matches the main speakers. You can keep the crossover on the sub at the max. It's only going to correct below 500hz. 

@George. To clarify : So when running the RC, I would set the sub volume at 50% and the frequency at 100%? If I am understanding that, would I then leave the sub at those levels when playing music?

Yes make sure you say yes to having a sub, volume at 50% and xover at max hz, if your auto setup room correction program is done using a microphone, the the program should do it all for you, even the sub phasing. I know Audyssey does, and it’s very good at it hardly had to manually tweak it all in my HT room.

Cheers George

Interesting.  Thanks. 

Hello puffbojie,

If the R528 subwoofers are connected via RCA to the sub outs on the C-658 streamer then you can leave them connected while the room correction program runs. If they are connected using the high level input to the speaker output terminals on the power amplifier, then we have found that it is best to run the software with the high level cables disconnected from the back of the subwoofers. In some cases when you have subwoofers connected using the high level input the room correction software will "see" the output of the subwoofers as being too much bass output coming from your main loudspeakers, and as a result the software will turn down the bass frequencies being sent to your left and right speaker channels. This can make it so that you're system lacks low-frequencies no matter how high you turn up the level on the subwoofers.

In our experience it is best to run the room correction with just the main loudspeakers connected and set to large or full-range within the NAD streamer, and after the program has finished you can reconnect the subwoofers and tune their level and crossover controls by ear to blend with the loudspeakers. 

We have an article on our website which could be worth checking out, that goes into detail regarding using room correction with REL subs:  https://rel.net/how-to-use/

Thank you- that makes complete sense.  

Room correction primarily addresses lower frequencies so they have to be on. That's the whole purpose.

Maybe the best solution is to just run RCAs to the c658 which is unfortunate because I think the high level is preferable.