replacement belt for a Maplenoll Ariadne

I'd contact either Lloyd Walker at Walker Audio or Pierre Sprey at Mapleshade Audio. One of them may have some information.

Here you go:

http://www.lpgear.com/category/M1.html

I would be a little cautious in ordering a belt from LP Gear.
I bought a belt from them specifically described as "Maplenoll Ariadne Signature turntable replacement belt" and it is too wide to fit on the pulley's flanges. The previous belt, sourced from Bob Dilger, is 3/32" wide and the belt I received from LP Gear is 5/32" wide. The result is that the replacement doesn't fit onto the pulley. I have sent them two emails, a day apart, and have not received a reply. There doesn't seem to be a phone number on their site, so I'm stuck waiting for a response. Granted it is a busy season I'll give them the benefit of the doubt.
A correct replacement belt should be 25" internal circumference, 3/32" wide and 1/32" thick based on the previous belt. So, far I haven't found a suitable source, but I did repair a small crack in the original, so it might be the default choice.

All's well that ends well. I received an email message, from LP Gear, giving me a return authorization so I'll send the wrong belt back today.

Well it is good to hear that LP Gear is giving you a return on the wrong size belt, but do they also have the correct size belt for your turntable. I have a round profile belt that I would like to replace or buy as a backup. It looks like it was custom made with a visible seam where the ends were fused together. My belt circles from the pulley all the way around the heavy lead platter and is approx 38" inches in circumference x 3/32"? round profile. Does anyone out there in Agon world know of a good source?