2. speakers
  3. 164043-2514

What is a good base for speakers

Fussing with setting up a new system in basement. My vintage ADS L710's sit on original stands that don't have fittings for spikes. As the stands sit on a carpeted floor, they rock a lot (no pun intended). I'm thinking of some sort of base to settle them down. Looking for suggestions of a material appropriate for stability  - any experience with wood butcher block, granite or slate cutting boards as a base? More DIY than expensive. Thanks for any suggestions. 
mcondo
dekay's avatar
dekay
5,349 posts
 
If they are the open backed metal stands add stick-on footers in a 3-point configuration (2 in the back and 1 in the middle of the front cross brace).

They sell little rubber stick-on footers @ hardware stores and online.

Whatever the stands are like 3-point/tripod support should help stabilize them.

DeKay


dweller's avatar
dweller
3,735 posts
 
I use some pretty decent amp stands for my B&W 804D3 speaks. Got them from AGon member Solidwood (Timbernation). With screw in cones came to $310. Had to drill them to secure but didn't take long.
Also, you could visit a Bed-Bath-and Beyond store and look at some big cutting boards.
fuzztone's avatar
fuzztone
5,498 posts
 
Drill
millercarbon's avatar
millercarbon
12,531 posts
 
any experience with wood butcher block, granite or slate cutting boards as a base? More DIY than expensive.

I have experience with all of these, which is why I recommend springs. Nothing else even comes close. And I am pretty darn good at DIY
https://systems.audiogon.com/systems/8367 Yes I built the table and stand. Springs are totally the way to go.
noromance's avatar
noromance
9,404 posts
 
2'x2' concrete paving slab. 
More to discover