Would switching amps make a big difference?

Most speakers are designed to approach a flat voltage response, not power, and amps to be a voltage source. If the source impedance of the amp is rather high (tubes) then there will be an HF roll off. The performance of a solid state amp might sound subjectively brighter but that’s not because it’s tilting up the highs, but because it’s not rolling them off. A speaker designer who designed a speaker with a highly variable impedance AND tuned it for a flat power response would be an idiot.

Most speakers are designed to approach a flat voltage response, not power, and amps to be a voltage source.

Agreed, but of course "most" doesn't mean "all."  It just means a majority.

If the source impedance of the amp is rather high (tubes) then there will be an HF roll off. The performance of a solid state amp might sound subjectively brighter but that’s not because it’s tilting up the highs, but because it’s not rolling them off.

The implication of this statement seems to be that in the case of electrostatic speakers, which are what the thread is addressing, that the tonal balance which results when a solid state amplifier is used is necessarily more correct than the tonal balance that would result with a tube amplifier.  If that is what you are saying I and I believe many others would disagree.  It's worth noting, for example, that the Quad ESL-57, which is revered to this day by many audiophiles, was designed before solid state amplification existed.

Regards,
-- Al
  

cdc2 OP

A strong solid state amp is always a good idea to try with ESLs

This is good advise, get the right amp that can handle Martin Logan Ethos sub 1ohm loads and -phase angles with current and stability.

Stay away from expensive "band aid" fixes like autoformers, save your money and get the right amp for the job instead, your Logans will reward you if you do.

The performance of a solid state amp might sound subjectively brighter but that’s not because it’s tilting up the highs, but because it’s not rolling them off.

I’ve owned many ELS’s this is so true with all Martin Logans, with the right solid state amps that’s stable and that can drive into that sub 1ohm load, you will get the highs that are "there" at the correct intensity and extended, not muted and rolled off.

Cheers George

The grass is always greener on the other side of the fence. TTTTTTTTTTT

((( I’ve been using a Belles 21a tube pre))) Why not check out the new Belles Virtuoso power amp? It has dual mono transformers sophisticated power supply, friendly 100 k input impedance, gain matches your existing Belles preamp, performs beyond expectation and its not digital. Please excuse my phone camera action
Best JohnnyR Belles Dealer
https://www.youtube.com/watch?v=BSyZuSyO76M