2. amps-preamps
  3. 149794-2897

Increasing volume

Hi all
I have an Octave HP700 with the phono stage module & a Lyra Skala. The gain in the phono module is on the low setting & the recommended load according to Lyra is 95.3ohm...I have it set at 97.

I want to drive the pre a bit more but it's quite loud at  the 10 o'clock position. 
Am I doing something wrong?
Any suggestions on how I can drive my pre a bit more...?

Thanks 
Rich
128x128infection
millercarbon's avatar
millercarbon
12,531 posts
 
One of the more common misconceptions, that the position of the volume control knob has anything to do with anything. It does not. YouTube has a highly informative video on this. Search for "Spinal Tap amp goes to 11."
infection's avatar
infection OP
805 posts
 
Excellent, very informative...
yogiboy's avatar
yogiboy
5,464 posts
 
If it is too loud at the 10 o’clock position something is not right. A preamp should work best in the upper range of the volume dial. Are you sure that the phono module is correct for the output of the cartridge that you are using? You should contact Octave to make sure you are using the correct phono module for the .5 mv output of the Lyra!
infection's avatar
infection OP
805 posts
 
@yogiboy  thanks for your reply. Any ideas about possible causes...?
More to discover