If it is too loud at the 10 o’clock position something is not right. A preamp should work best in the upper range of the volume dial. Are you sure that the phono module is correct for the output of the cartridge that you are using? You should contact Octave to make sure you are using the correct phono module for the .5 mv output of the Lyra!
Increasing volume
Hi all
I have an Octave HP700 with the phono stage module & a Lyra Skala. The gain in the phono module is on the low setting & the recommended load according to Lyra is 95.3ohm...I have it set at 97.
I want to drive the pre a bit more but it's quite loud at the 10 o'clock position.
Am I doing something wrong?
Any suggestions on how I can drive my pre a bit more...?
Thanks
Rich
I have an Octave HP700 with the phono stage module & a Lyra Skala. The gain in the phono module is on the low setting & the recommended load according to Lyra is 95.3ohm...I have it set at 97.
I want to drive the pre a bit more but it's quite loud at the 10 o'clock position.
Am I doing something wrong?
Any suggestions on how I can drive my pre a bit more...?
Thanks
Rich