Micro Max 282 vs. Exclusive EA-10


I have mounted an Exclusive EA-10 on my Micro (I added a pic to my system), one of the most expensive Japanese tonearms, maybe a little underrated. The tonearm and the tubes are re-wired by Ikeda silver wire. The EA-10 reminds me very much of the Max 282, most properly it was built by Micro Seiki. Does anybody know if this is true?
thuchan
Dear Logenn, IMHO the Ikeda silver inner wire is the best of all worlds. Very flexible, very pure, pretty heavy gauge and superb insulation which can (if one knows how) be stripped without the slightest harm to the conductor.
I use Ikeda inner wire since 20 years now and had nothing but the very best results with it.
Most of the great tonearms from the past to suffer from poor inner wiring.
If you look at several top-flight-tonearms of today, you see that many of them sport inner wiring of high caliber and sometimes even prime trademark.
It certainly is an essential part of their performance.
In tonearm we are dealing with the lowest and smallest (read: most fragile) incarnation of the audio signal.
Careful inner wiring with highest conductivity metal is kind of "clearing the alley for the sonic parade".
Cheers,
D.
Hi Ddriveman,

I give all my arms for rewiring to Dertonarm, it`s not cheap but you can trust the quality for years. I always go for new DIN-connectors, the old ones you may send to the moon. Some guys use them again due to "vintage& original design". They never anticipate you open up the arm again...

best & fun only - Thuchan

Dear Thuchan and Dertonarm- Appreciate your thoughts on the silver Ikeda wire for the Max 282. I should receive it this week and we may have a listen to it for a few weeks. I have a Dynavector XV 1S just back from Soundsmith and I may try this cartridge in the Max with a Crystal Cable tonearm wire.

I have been thinking about rewiring my Audio Craft 4400 to silver wire for some time and perhaps i should have it done as well.

I am also still in shock at how good the rx 5000 is performing. I am using it with a thread as recommended by Dertonearm.

All very good stuff.
Dear Logenn: As Thuchan pointed out the best " solution " is goes from very up-front ( tonearm-cartridge connectors. ) down to the phono stage input ( no SUT Thuchan because there are, between other things, additional " joints ". ).

I already tested no less than 20 different tonearm wires ( internal wire. ) and there are several that IMHO are better performers ( neutral. ) than the Ikeda one that I tested too.

Two of them are the Audio Note ( UK. ) and this one:

file:///C:/Documents%20and%20Settings/Ra%C3%BAl/Mis%20documentos/silver%20wire.htm

That Dertonarm used in the last 20 years the Ikeda IMHO only menas that in that subject he does not grow-up/improve.

Crystal that you are using is very good too as is Nordost one.

Btw, as usually I'm not commercialy biased on this internal wire subject.

Regards and enjoy the music,
Raul.