rauliruegas

Responses from rauliruegas

How important is the efficiency of a speaker to you?
Dear @daveyf   .: You are rigth and I was lucky enough to found out all the power supply, protection circuit, input electrical circuit electrolithics at its original values through the best of the best caps: Vishay. When I did it ( less than 2 ye... 
Found a Milty Zerostat alternative
Thanks @lewm     R.  
Mint Protractor. A Pretty Nice Alignment Tool
Dear @neonknight : " The Mint protractor is built specifically for this arm. "   NO, that’s where you misunderstood strated and belongs because the MINT LP protractors were made not for an specific tonearm ( this does not matters. ) but for an ... 
Found a Milty Zerostat alternative
Dear @newfzx7  : What are you waiting for ?  Thanks to share it.   Regards and enjoy the MUSIC NOT DISTORTIONS, R.  
How important is the efficiency of a speaker to you?
Dear @daveyf  : I know and listened sevral times in different home top room/systems the original JC 1 and the JC 1+ too.   But, I don't need to buy it because my Levinson 20.6 monoblocks was and till today it's the J.Curl Statement Design. Yes b... 
Mint Protractor. A Pretty Nice Alignment Tool
@neonknight  : Please do it a favor and don't insist in something where you have a clear misunderstood. The designer protractor you own was in specific for a P2S distance to achieve minimum tracking distortions in the designer alignment choosed a... 
How important is the efficiency of a speaker to you?
@daveyf  : As many others including what posted that gentleman ceratinly did not read yet te JC 1+ review that between other things states:   "  The JC 1+'s shielded input- and driver-stage circuit boards use an FR408 substrate, a substance tha... 
TONEARM DAMPING : DAMPED OR NOT ? ? USELESS ? ? WELCOMED ? ?
@mijostyn : You need to go out for a few minutes from your little world. Btw, the key in this cartridge main issue is the choice and quantity of silicon viscosity level we are using it.   R.  
Mint Protractor. A Pretty Nice Alignment Tool
No, it's not. Please make a revise to the alignment Löfgreen equations where the only input parameters are: tonearm EL and most inner/outside distances. Those equations gives to you the overhang and offset angle but it does not calculates the P2S... 
TONEARM DAMPING : DAMPED OR NOT ? ? USELESS ? ? WELCOMED ? ?
Dear @mijostyn  : With all respect to you what in " hell " you did not undersand from my last post that are not my words but the gentlemans/researcher Crandfield Institute where them belongs to the Departament of Design of Machine systems. Townsh... 
Mint Protractor. A Pretty Nice Alignment Tool
Dear @neonknight  : The MINT LP protractor is a dedicated one made it for an specific P2S distance and does not works for a different P2S distance. Normally those protractors were made for Stevenson Alignment and under ask by customer for Löfgren... 
How important is the efficiency of a speaker to you?
Dear @daveyf  : About the JC 1+ I was refering to the speakers in demo by the seller in your OP and not about the owner of those Parasound amps that btw can handled with out problem to high SPL that 1 ohm impedance.   R.  
How important is the efficiency of a speaker to you?
Dear @daveyf : The issue thatan amplifier working harder develops higher distortions could not be exactly as was posted. You can read in the link that the JC 1+ gives you at full power output same distortion levels at 8ohm, 4ohm and 2ohms: 0.15%.... 
How important is the efficiency of a speaker to you?
Dear @daveyf  : IN any case and not so expensive you can find out the  Parasound JC 1+ monoblocks that when you listen it in any speaker at any SPL you did not ask if you are listening tube or SS amp but only enjoying MUSIC. John Curl is a very l... 
JL Audio Fathom
Hi @james633  : " Harrison Labs inline highpass  $27 ( single capacitor installed between the preamp and amp) "  It seems to me the best alternative/option for @upstateaudiophile  As a fact I'm doing something similar directly in my ML 20.6 monob...