VPI 78 RPM pulley for motor ??

First off, Harry is very much alive and enjoying his semi-retirement.  Second, VPI has been closed for the holiday.  They are back to regular hours.

(732) 583-6895

[email protected]

Curmudgeon perhaps a better word, and I think I spelled it right.

I had already written Steve at VAS and asked him if he has any advice for you. Let’s see his response, hopefully tomorrow.

Step outside, read your posts as if someone else wrote them, get your smile back.

These people might know a source

https://www.analogueseduction.net/vpi-upgrades-parts-accessories/vpi-two-speed-pulley-specify-motor-and-platter.html

https://houseofstereo.com/products/vpi-industries-two-speed-pulley?pr_prod_strat=e5_desc&pr_rec_id=cf33b1417&pr_rec_pid=8515819700373&pr_ref_pid=7432645836949&pr_seq=uniform

https://www.renaissanceaudio.co.uk/vpi

/////////////////////////////////////

"You’ll need an AC line voltage regenerator with variable frequency that can go up to 105Hz and beyond to play 78rpm with a 45 pulley, since the speed of the synchronous motor is set by the wall outlet frequency. The SDS only goes up to 90Hz.

A good reverse-engineer can perhaps modify an off-the-shelf AC inverter to put out a different frequency, as was done here. "
 

I talked with Steve at VAS and he knew nothing of the 78 pulley........W

I talked with Steve at VAS and he knew nothing of the 78 pulley........W

Well I'm happy for Harry, being alive is very good........I just found out they were closed.........So I will call them later...........Will