To antiskate or not antiskate

@thebrokenrecord +1 for Wally Tools / Wally Skater. I have the complete set as well as microscopy analysis with custom shim. This is the way to go. 

I posted the report in my virtual system.

Check out at the Zenith error in my cart. Published tolerances are +/- 5% which is a lot, but can corrected if you know what it is and have the right tools.   

It wasn't a budget helper at about $450 here in Europe 😳 but in regards to the rest of the gear it's coffee change or there about 😆

1. Use blank side of LP, raise arm, get platter spinning 33 rpm.
2. Lower arm, it gets pulled into the center, that is natural skating force
3. add a little anti-skating force, lower arm, a bit more. Check it at various distances from the outer and inner grooves. Find a compromise, if any allow a speck of inner skate, avoid outer skate.

Sorry, but this does not work very well, if at all. By ear yes, but it helps to know you're in the ballpark to start with.

Exactly, get in the ballpark visually, (ignore the dial) then refine by ear, using what LP______?

AFTER: everything else is verified, anti-skate is last

AFTER: Your system’s balance is proven by the CD version of whatever content you are using.

Then use the LP version of known content and known imaging

...................................................... 

Just last night, listening to a friends system, track 3 ... the left channel disappeared. Nobody walking around, nobody touched anything.

WTF

Turned out to be a loose RCA connector on the back of the Phono stage.

That’s why I changed to all LOCKING connectors, either Locking XLR (they all do not lock); or cables with Locking RCA connectors, or modify your existing cables with these connectors from parts express

https://www.parts-express.com/Locking-RCA-Plug-Solder-Type-2-Pair-091-1270?quantity=1

The channel disappeared completely, easy to be aware off, find and fix, but many times you can get a partial signal, unaware your balance might be off

Here I run everything balanced,  I even make my own cables because they are better than anything else that I've tried. 

It's been a while since I've used the blank record trick but it might direkt me in the right direction ,or I might just wait for the right tools 😁