Amplifier recommendations for 86 dB Sensitivity Speakers


Hi,

I’m considering a pair of Technics SB-G90M2, they have good specifications on paper; however, my only concern would be their 86 dB sensitivity. 

My current amplifier is Cayin A100t, which according to its specs, outputs 70 watts into 8ohms. the Technics are 4 Ohms; so, I assume my Amp could deliver 100-140 Watts into 4 Ohms. Unfortunately, I couldn’t find more accurate information about my amplifier, and it only shows the output power at 8 Ohms equipped with KT-88 output tubes (mine came with EL-34s), therefore, it’s unclear what the real output powerat 4 ohms is.

Wondering if this tube amplifier would be a good match for these more demanding 86 dB speakers? I’m aware of impendence fluctuations and I know the Amp can drive them just fine, but I am not sure if 100 watt per channel -assuming that’s what my Amp can deliver into 4 Ohms- would be enough for these speakers to make them sound as intended, meaning, good sound quality.

(I don’t nor am planning to listen at high volume but have a larger room with high ceilings).

Below are the specs.

Many thanks,

 

Technics SB-G90M2 Speakers 

  • Type: 3-way floorstanding speaker with bass reflex
  • Woofer: 2 x 16 cm
  • Midrange: 16 cm
  • Tweeter: 2.5 cm
  • Sensitivity: 86 dB
  • Impedance: 4 ohms
  • Frequency range: 33 Hz – 90 kHz (-10 dB)
  • Crossover frequencies: 500 Hz, 3400 Hz
  • Maximum power handling: 200 W
  • Recommended amplifier power: 40-200 W
  • Dimensions and weight: 111.4 x 29.2 x 36.6 cm / 35 kg

 

Cayin A100T Integrated Tube Amplifier 

Power output: 70 watts per channel into 8Ω (stereo)

Frequency response: 10Hz to 65kHz

Total harmonic distortion: 1%

Input sensitivity: 480mV (line)

Signal to noise ratio: 89dB (line)

Speaker load impedance: 4Ω to 8Ω

Valve complement: 8 x KT88, 2 x 12AU7, 2 x 6CG7, 1 x 12AX7

Dimensions: 440 x 210 x 397mm

Weight: 29kg

mamifero

@atmasphere, you basically restated what you said earlier in this thread and it's a very sound argument.  I just don't think you are allowing for individual, subjective taste.  We've both participated in this forum for a long time.  One of the things that has been revealed to me is that not everyone has the same goal(s) in assembling/setting up their systems.  It's not even an accuracy vs. musicality schism in that there's not a solid agreement as to what those terms mean.  (There's actually a lengthy thread trying to define "what if high end".  The responses are quite varied.)  Instead our music reproduction systems are more of a reflection/projection of ourselves as audiophiles.  Just look at the variety of systems people have.  As such our systems can be technically imperfect or non-optimal, yet the listener still is very happy with the sound.  If some people want to pair Magnepans with single ended triode amps, my response is go for it and tell us how it sounds.  You want to place big Wilsons in your 12' x 12' room?  It might not be something I would do, but go ahead an give it a shot.  So while I have an opinion about matching the Technics with the Cayin, I and nobody else in this thread can truly predict whether the the OP won't like the combination.

Let's not get all boring and start agreeing on everything.

@onhwy61 I agree, however for me its really about how it can sound even better and thus be enjoyed more too. Put another way its about getting the most out of your hifi investment. 

 

Review Technics SB-G90 floorstanding speaker 

''So you have been able to read that this Technics is a big heavy, 3-way bass reflex speaker. So far so good. The nominal impedance is 4 Ohms and the continuous load 100 watts. 200 watts peak. That’s more than enough for many a living room. It takes about 40 watts to get it going. We estimate that a tube won’t go very well, but who knows with a heavier 300B it might work, considering the efficiency is still about 88 dB. That’s not super high, but it’s not low either.'' see review here

Mike

Based on my experience trying to match 86dB speakers with a tube amp, the size of the woofer and controlling that driver have a lot to do with whether a tube amp or SS will work better. The JBL woofers are not that large. If you can demo them, do so. But as you have not purchased the speakers, and if you can't demo them with your amp, I'd look for better synergy on paper.

I ended up with SS. You can see my set up in my profile.

As for power, in a semi-contained listing area that opens to a much larger open plan living space, I'm generally using 10 watts or less p/c and filling the space nicely. Volume range -40dB to -30dB albeit with virtually unlimited headroom.

I have a pair of Vandersteen VLR-CT bookshelf speakers which are 86dB, my least sensitive, in a 2.1 system. I have used both a Yamaha A S-2200 (90W AB) and a Peachtree Carina GaN amplifier (200W GaNFet Class D). Both perform well with these speakers. I would suggest you use  a moderately high powered SS amp