2. amps-preamps
  3. 160198-151267

I blew up my receiver. Now what?

I brought my Integra DTM7 to Europe. Plugged it in, and POP! I discovered that unlike my other electronics, it definitely could not handle 220v wall current. Smoke poured from the vents for a while, even though I immediately unplugged it. 
So:

1. What did I break? A fuse? A capacitor? Everything?

2. What’s the best way to get it back up and running here in Europe?

thanks!


jmk2
audioguy85's avatar
audioguy85
1,989 posts
 
The above beat me to the punch....it would not have even fit the receptacle...a step down transformer may be a good investment in future. 
bigkidz
3,312 posts
 
Most likely took out a few capacitors and resistors and probably the output device.  Hard to tell. Pop the top and see what the damage is.  Check the transformer.
 Good luck.
stringreen's avatar
stringreen
6,368 posts
 
I thought the different plug design doesn't allow you to do this kind of damage.
wturkey's avatar
wturkey
722 posts
 
Once the magic smoke is released.......
asvjerry's avatar
asvjerry
4,266 posts
 
BBQ'd any other devices?

"...I love the smell of fried circuitry in the evening gloom...."

Once upon a time, some equipment had that small 'fail-safe' switch that read '110vac><220vac' by the line cords' strain relief.
If one was lucky, and it was new, the 'gender bender' plug that allowed for Euro wall sockets...

...but I guess I'm just showing my age....*tapping cattle-prod cane on the floor softly to a beat*
More to discover