Ground loop feedback - cable wire issue

I have had this issue with my office.
I even sent my amps and preamp to Atmasphere to sort it out, but, to no avail.
It seems some amps don't play well with other equipment.
I think it might be some inherent design issue with the amp, but I am no EE.

Have you tried a 'Hum Buster' or tried to float the ground on the amp?
Bob

It’s just the cable co.
They have a different ground than your house does. Put a Ground Loop Isolator for Cable TV applications F Connector on the cable feed. I have a bunch I paid $8@. MCM used to have them but they’re gone.
Some are on eBay. Best $15 you will ever spend.
Nothin' to do with amps

Yup, I went through the same thing as fuzztone with a cable box, and Power supply.
15.00 usd fixed like new, with a great little GL gizzmo. 3 or 4 (options) one was with a wire added to one of the devices, I didn't have to use it..

Safety first, protection second. I always protect MY expensive gear.
I have NEVER suffered SQ loss.

Great power supplies, in equipment go a long ways. Krell, Mcintosh. Pass, and a few others don’t squeeze where it REALLY counts, the Power supply. A ZERO noise floor for me...

A little test....

TURN the volume ALL the way up with nothing playing, on your vinyl rig, SDAC or something.. Is there ANY noise? No noise, you did a good job.. It’s hard to do for some folks.

A LOT of  listeners just say I can't hear it when it's playing so what's the difference... I guess it's just me.. I'm picky, REAL PICKY.  Even my 600.00 special system had NO noise, FINALLY.. Took a day or two..

Regards

agree with @fuzztone - it's likely related to cable and those products address those problems quickly if the cable ground is the root cause.

If for some reason that doesn't work it means that your new amp is interacting poorly with another component connected to it and sharing the same ground.  I just went through this with a SET amp I acquired.  Turned out the interaction was with my preamp.  I diagnosed the problem and ultimately resolved the problem using a Hum X to float the ground on the preamp.  

Besides floating the ground on the preamp I found that I needed to make sure my DAC wasn't sharing the same power strip/conditioner with the amp because my single ended ICs connecting the DAC to the preamp enabled the ground loop to remain intact.  Yes, it took several hours to track this issue down.

Also I don't think it's a good idea to float the ground on the amp or use a Hum X -type device directly on the amp (even though it will remove the hum).  The Hum X is only safe up to 6A draw and many amps can spike above that.  My 48W SET amp was drawing 4.5A at idle for example.  It's better to float the ground on the low draw component that's cause the poor amp interaction.  In my case my VAC preamp only draws 0.5A according to my measurements. You certainly don't want to create a safety hazard while addressing the ground loop/