Thiel CS 3.6 amplifier selection Monarchy SM 70?
Masi61 - I don't mean to misdirect you, but the tube amp I'm using was custom built for the Thiels. The original version had a 4 ohm tap and could not do an adequate job with the Thiels. Once, this was changed to 3 ohms the difference was monumental. For years, I powered the Thiels with a CJ Premier 11a and they sounded very good. Today, my custom amp from Sam's Audio Labs rivals the somewhat colored CJ in resolution, bass, extended treble, and power. See this old and short article from Soundstage. http://www.soundstage.com/rise01_4.htm What's most important is that you audition different amps with the Thiels because it's only your ears that matter. |
Wow! Thanks for the interest in this subject. Thanks Kenny for the recommendation of Sam's Audio. Did you send your own tube amp to him and ask him to modify it? Or did he build it from scratch? How much does something like this cost? Jeffrey, thanks, I may call Monarchy Audio to audio to ask about their SE100's, to be honest with you, the thing I liked about the little SM70's is that they run the balanced XLR inputs which I think is cool because you could put little amp stands right next to each speaker and run longer XLR interconnects from your pre-amp. This would also allow shorter runs of speaker wire. Right now I'm rather broke so I'm looking into using my NAD 2200 power amp for the Thiels. I don't want to even try it until I get the transformer hum (that I have written about in another thread here on Audiogon) fixed. I did email Sam's Audio and several other repair places around North America to see If they can build me a new power supply at a reasonable price (preferrably under $250). I had an audiophile update done on this amp last year and believe it sounds quite good and might even be a good match in the short term while I scrape some money together for the Odyssey Stratos SE. |
Mais61, If your looking for a pair of mono amps with XLR inputs to adequately drive your 3.6's on a tight budget, you might want to keep your eyes open here for a pair of used B&K M200's. Caveat; not all B&K M200's came with balanced inputs, and B&K recently went out of business, so factory support won't be there. On the other hand these were fairly simple, yet robust designs that other outfits used to modify. I would think you could find outside help in the unlikely event that you needed them serviced. While these wouldn't be my top choice as the best sounding amps for your Thiels, they're darn close. Recently they've been selling for about $800 a pair here on Audiogon, and at that price are an absolute steal. |
