New Magico Speaker the Q3

Bvdiman,
I think the ability of the user to tighten the pucks on the back of the V2 and M5 has more to do with the movement inherent in wooden enclosures due to temperature and humidity changes. These built up Baltic birch ply enclosures move over time. The aluminum enclosures should move less with changes in humidity. I don't know about changes in temperature. The other concern is the movement caused by the massive pressure inside the cabinets created by the sealed design. One would presume that Magico did extensive testing in the area.

Hi peterayer, yes, my main concern with the Qs is mainly due to what continuous massive internal pressure from powerful woofers in sealed enclosures would cause over time (where those numerous screws and threads reside).

There are several ways to make sure that the threads will not come apart. There is a type of Loctite that WILL NOT come apart unless it is heated. Another method is to physically stake the first thread of each fastener. This is an actual physical deformation of the thread. The end result is like if you have ever try to remove a nut from a bolt that has had the threads have been peened over, pretty much impossible. From the looks of the enclosure, this could be tougher to do unless a special tool is developed, but I am sure this could be done. I am sure that all of this was taken into consideration when the skeletons of these speakers were designed and built.

Csmgolf beat me to the same answer, calling Magico would give a good insight too.

out of subject

Bvdiman,

I have just seen the picture of your system ... how does the Soulution compare to the FMA ?