2. amps-preamps
  3. 146351-108136

What setting should my amp’s input sensitivity switch be set at?

I am hoping someone can help as I am not an engineering type. I have an integrated Vitus amp connected to a CD player via an rca cable. The amp has a sensitivity Vrms setting for each input. It has three settings <2, <4, and <8 vrms. Would anyone know what this should be set at? The lower the setting the louder it goes but I am sure there is more to it than that.

Thanks for any advice you can give.
128x128duckworp
5 responses Add your response
Post removed 
duckworp's avatar
duckworp OP
256 posts
 
Thanks for your help. 
Post removed 
millercarbon's avatar
millercarbon
12,531 posts
 
don vito is right. Leave the gun, take the canoli. Er, I mean use the one that sounds right.

The non-technical way to think of this is, you know how sometimes you have to turn the volume up (or down) a lot when going from one source to another? Vitus is simply giving you a way to make them more the same volume. Its a convenience feature.
donvito
393 posts
 
A CDP has an output of 2 volts which is enough to drive your amp. If you find it is too loud just change the setting on the amp to a higher setting to lower the volume. That is a nice feature on that amp!
Log in to respond
More to discover
80x80
Valab LCR-1
80x80
Ayon Audio Spheris III Tube Pre-amp
REFERENCE TUBE PREAMP
80x80
T+A M 40 HV Monoblock Power Amplifier