Streaming: WiFi or wired??

@classdstreamer what low noise power supply did you add to your modem/router?

@rsf507 
I used iFi power supplies. They have two different models to match most various voltage and amperage requirements for streamers, DACs, modems and routers. iFi is relatively affordable, which makes it a perfect to start to see if you hear a difference compared to your streamer's wifi card. If you do try a low noise power supply with your modem and router, I'd be interested whether the difference was obvious (or worth the cost) in your system. 

Just as a side note, I suspect that a reclocker and power supply / power cable upgrade should be prioritized over power supplies for the modem and router. iFi also makes a few reclockers in case you haven't tried one. I suspect that a Node 2i, for example, would benefit from a reclocker; but I also suspect that most Node owners don't run a reclocker. 

I’m late to the discussion here. However, I thought it was important enough to bring up something obvious regarding the Orbi system.

I am using the Orbi system with a Cat 8 ethernet cable connection to my Gold Note DS-10/ PSU-10 Evo combo.

I was quite satisfied with what I was getting and then it struck me that what I was hearing was only as good as what was being transmitted from the Orbi router to the Orbi satellite.
I was still using the cheap Cat 5 cable that was included between the cable modem and Orbi router!

I swapped to Cat 8 cable between the modem and Orbi router.

The result was a jaw dropping change in sound quality in every respect. 

The lack of basic understanding of networking, hell, even basic physics is somewhere between amusing and appalling. 

Digital SQ begins with sample rate and bit depth. For a CD that's 44.1 KHz and 16 bits. 16 bits isn't adequate to avoid detail loss of low level signals, that requires 24 bit depth.

As for Ethernet, as long as the network is cable of sustaining ~1.5 Mbits/sec it is adequate for CD quality Bitstream, 5 Mbits/sec for 'Hi-Res' Bitstream, 100Mbit/sec enables multiple devices to share the network successfully, but nothing more. Wi-Fi or wired makes no difference, nor can it. If external sources cause enough interference to cause buffering or dropouts, that is no more Ethernets fault than blaming your speakers for not playing louder than the jackhammer down the street. 

Spend a little time with the 7-Layer OSI model and a basic TCP/IP primer and it will shortly equip you to understand what is real and what is hype.