Left / Right Maddening Problem


Hello all,

I have a conventional 5.1 HT / music system: DVD, CD, Pre-Pro, front amp, 3-channel amp for surround and center and self-powered sub.

For a test CD, I use the Stereophile Test CD 002-2, which provides a dog barking to verify left and right channels, a bark that should come from between the two front speakers and an out-of-phase dog bark.

Both the CD and the DVD (with the center and rear channels turned off) exhibit the same anomaly: the left dog emanates from the right speaker, while the left dog comes from the center. Neither is distorted. The center dog bark is perfectly placed and undistorted. The out of phase dog is indistinctly located and somewhat muffled - which is the expected behavior.

Since the CD and DVD are connected to the pre/pro at separate inputs, I think I can rule out the units themselves as being at fault.

I changed the front amp and got the same result. I changed the pre/pro and got the same result. I changed the connecting cables from the CD and the DVD, which also made no difference.

I deliberately reversed the power and ground on one front speaker, which did not help.

Also, I ran the test setup from the pre/pro to make sure that left and right speakers are correctly connected and identified by location.

Lastly, I played the test CD on a boombox to be sure that it does, in fact, produce the dog barking from the left and right side speakers - which it does.

So, now I am unashamedly stumped and am appealing to you all for help. (My wife would also appreciate a resolution to this issue since my testing is making her nuts.)

Any and all suggestions will be welcomed.

Thanks.

Jon
opteron05

Showing 1 response by ozzy

The most obvious and always overlooked is that the speaker wires are reversed.
I know, we all say thats impossible , but it is easy to do.
Also, perhaps the wire inside the speakers is reversed.

So, start by double checking the speaker wires, and then try other speakers.