2. tech-talk
  3. 1223183212

200-amp Breaker Panel Question

My current 100 amp panel is being replaced tomorrow with a 200-amp panel with a copper bus (along with my meter box outside so that the electric company will then run 200 amp lines to my home rather than the current 100 amp service). I've read conflicting opinions here and in other forums regarding whether your dedicated lines should be on the same phase while also trying to place the noisier appliances (dryer, refrigerator, AC etc,) on the opposite phase. If you have any actual experience with this topic or are an electrician and an audiophile, I would certainly appreciate your input to help me resolve this issue.

I am also planning on having my dedicated lines on the first circuit breakers after the power line enters the breaker panel.

I cleaned the copper bus with CRC and treated it with Caig Pro Gold. Of my six dedicated lines (all of which are home runs), 4 of them are 10 gauge conductors in flexible Greenfield conduit and two of these are for my monoblock amplifiers and will be linked to 30 amp circuit breakers. Finally, for various reasons, neither a sub-panel or second mains panel are options at this time.

Any other suggestions you can think of?

Thanks in advance for any assistance you may provide.
fmpnd
rodman99999
5,985 posts
 
One of these products on every electrical connection: (http://www.walkeraudio.com/sst.htm) Do place the system on the opposite phase. You'll avoid any voltage drops when the appliances are starting/running, if nothing else(you'll still have the same neutral).
stenersr
84 posts
 
Hi Frank, It has been a long time and glad to see you are still making improvements. I am still tweaking also and am currently comparing Analysis Plus power cable vs. Romex 10/2. It is a huge difference and posted some comments on another thread. The cable is not cheap but I found the difference totally worth it. If you want to know more just let me know. Regards, Bob
fmpnd OP
481 posts
 
Hey Bob! How's your system these days. I will look into the AP cable, especially since they are very close to my home. I still have your phone number so I may give you a call if that's ok.

Rodman, I actually have the Walker Extreme SST but have always been a bit cautious on where I put it - I did put it on my tube pins but have yet to try it on electrical plugs (but this may be the time to do so). My buddy Rushton is a big believer in the SST and sings its praises. I know to use it sparingly but I never thought about it in the panel box. Are you suggesting I use ith there? Is there any potential problem with it deteriorating with age and needing to be cleaned and re-applied? If so, I would think treating the copper bus on the breaker panel would not be a very convenient connection to do so. Thanks for the imput on the phase question.
tweak1
3,534 posts
 
I read somewhere to actually get a separate panel for your A/V system(s)
fmpnd OP
481 posts
 
Tweak1,

I have also heard that and I was considering having a second "mains" panel (not a sub-panel) but certain logistical problems prevent me from doing so.

Thanks.
More to discover