2. tech-talk
  3. 1209317773

Dedicated circuit's' ? or one dedicated circuit?

Hello all, I am building a new dedicated sound room and I am trying to figure out if I should run several seperate dedicated circuits or run one dedicated 30 amp circuit to one outlet. Then run a power distribution strip (Furutech, Oyaide) from that single dedicated outlet. I would then plug all my components into the strip. 30 amps should be plenty to supply all of my components. My main goal/idea behind this layout is to keep it simple and to optimize the grounding. I know most people run a bunch of seperate dedicated lines, but I have talked to several very knowledgeable audio folks that say to run all components from one circuit. The problem, I would think, is finding audio grade outlets, plugs, connectors. I suppose the strip would have to have all 30 amp receptacles? and, of course, all of the power cords would have to have 30 amp male plugs? I don't know? Is this possible to do?

Does anyone have any input on this?

Appreciate all responses
128x128keithmundy
lak's avatar
Ag insider logo xs@2x
lak
4,532 posts
 
No doubt about it in my mind; several separate dedicated circuits to your audiophile quality outlets and keep the digital gear on its own circuit.
There are dozens of other posts asking similar questions in the Audiogon forums. I suggest you do a search.
I would also suggest at least two dedicated circuits and use the Porter port outlets, somewhat inexpensive ($36/each) but well built and cryo’d.
http://forum.audiogon.com/cgi-bin/fr.pl?raccs&1065488253&openfrom&1&4#1
thorman
1,262 posts
 
I agree with Lak ;;;Porter Ports too...I would suggest 3 lines...2 Analog and 1 dig.. You just need to know where and how far apart to make it work well....If you don't do 3 lines you will be kicking yourself later......
sufentanil's avatar
Ag insider logo xs@2x
sufentanil
782 posts
 
30 ampere outlets require very special 30A plugs. They're not common to see on typical audio equipment. I would use 20A circuits with 20A outlets; they are backward-compatible with 15A gear.

As to whether you should wire multiple ones, just keep in mind that different circuits might have a slightly different ground potential, and hence cause a ground loop (hum).

Michael
keithmundy's avatar
keithmundy OP
106 posts
 
Thanks guys for responding.

Ya, Sufentanil that is my goal - to keep it simple and more than anything - keep the potential for grounding problems to a minimium. That is the main reason I would run one bigger(30 amp)circuit - grounding.

I suppose 30 amps is over kill though, as every power distribution strip, balanced power, power conditioner, etc... is 20 amps. And apparently lots of folks plug all their stuff into one of those units and it works just fine.

I think probably what the guys that are running one 30 amp are doing is running the 30 amp into a 20 amp plug which I'm sure is not to code, but that's got to be what they are doing.

As I am coming to realize - running everything to 30 amp code would be a pain in the ass and a little unrealistic I suppose.

OK then. Thanks again for the responses
More to discover