Help power pair of Infinity Kappa 9's please


Hi all!
I have a pair of Infinity Kappa 9's:
Nominal Impedance: 4 to 6 ohm
Power Rating: 60-340 watts RMS
Efficiency: 102 dB SPL @1 watt, 1 meter
Crossover Frequencies: 80Hz, 800Hz, 4500Hz
Frequency Response: 29Hz-45kHz +/-3dB
Physical Attributes:
1x - SEMIT Supertweeter
1x - EMIT Tweeter
1x - 3" Edgewound Voice Coil Polydome Midrange Driver
1x - 5" Polypropylene/graphite Diaphram Polygraph
2x - 12" Cast Frame , L/C Tuned Woofers
Dimensions: 59.5"H x 21.5"W" x 8"D

My room is 12'x12', I have $2500 budget and would like to play music off my computer. I need amp(s), a preamp, and a DAC i guess (is the DAC necessary at my low of a budget range?). I know my budget is low so I will be shopping for very used/old equipment. If anyone has any experience, suggestions, or words of wisdom, they would be very much so appreciated.
Thanks,
JT
jtiesel2
Jtiesel2,
Do the surrounds actually have holes in them or are they just becoming weak?
I've posted it on Audiogon before. If you have some old latex paint sitting around, open it being careful not to shake it at all. The latex and pigment will be seperated. Several small coats of latex will bring those surrounds back fairly well as long as there are no holes to deal with. Make sure that you use only the clear latex that typically seperates itself from the pigment. I've done this at least 100 times. It works very well. Also,
There are a couple of old threads on audiogon where people had success with Kappa 9's. Here you go:

http://forum.audiogon.com/cgi-bin/fr.pl?cspkr&1184547409&read&keyw&zzinfinity
Oh man! They were totally fubar!! I spent a few hours learning and fixing them though, it was a fun learning experience. I think it went well they look great!
At least 100 times? You do this for a living?? Thanks for the link!
Hi Jtiesel2,
I ran SpeakerCraft/Marcof electronics, back in the early 80's. I had my own Stereo Store a few years in the late 80's,early 90's in St. Louis called Sounds Right. I've been a manufacter's rep for high end audio and 12v. I've built and repaired more speakers than I care to mention. I'm glad that it worked out for you. Tim
I was going to recommend an Aragon 4004 mkII.Those amps were even used in Discos(abused would be more accurate),but after reading the posts,I thought I better not.I just ran into this article.I'm familiar with the Apogee's amp blowing reputation. This article gives an idea of some amps that ought to be able to drive them. Link..[http://www.apogeespeakers.com/scintilla.htm]