SME 20/2 Finger Lift Hum

It's certainly a workable solution since it's what I am doing and when actually playing a record it sounds fantastic, but I will still be experimenting until I find a 'permanent' solution. The concern about the tight and rigid coupling with the Lyra to the headshell being compromised is a concern of mine as well if nylon screws are used. Thanks for all the advice. We'll see where this goes.

If the SME V arm tube is anodised, then this explains why it doesn't hum when touched- anodising gives a non conducting surface.
The question here is what finger lift are you using. It would seem to me when you are touching the arm lift or cartridge bolts you are creating a ground loop.
If my theory is correct then finding an arm lift with a non conductive coating is the answer - and gets rid of the plastic problem. Another solution you might find more elegant would be to put some heat shrink on the arm lift - just the part you touch. You can get different colours including clear.
You could also try wearing rubber soled shoes or put a rubber mat in front of the tt to stand on to break the earth loop.

I have an SME V arm and have never installed the finger lift. I don't want another piece of metal that could vibrate a tiny amount between the headshell and bolts near this sensitive part of the arm and cartridge. I don't know if this sounds better or even different as I have never compared, and perhaps it is just a silly precaution, but rather than take the chance, I just left it off. My dealer also suggested this when I bought the table years ago. It looks more elegant anyway, IMO and I don't miss the convenience of the finger lift. This should solve your problem.

Dear Dover, If you re-read the thread you will see that every single point you made has already been made, and your "theory" has already been proposed. At least you and I and others agree. Insulating the finger-lift has apparently worked to eliminate the hum; the OP is not totally happy, however.

Lewm, not quite correct. Additional observations were
I was explaining to the gentleman why touching the SME armtube did not induce hum - anodising.
Provided additional options for insulation on the arm for aesthetics - get a painted one or use heatshrink rather than plastic.
Rubber shoes/mat I cant see anywhere - a bit off the wall, but I have seen this work.
I refrained from suggestions like removing his pacemaker or turning the cellphone off.
I have also seen hum issues or rf issues where there have been poor solder joints in the cable loom between the cartridge phono input sockets that whilst hum is not present, touching the arm induces it - not a ground loop issue, more of an antenna effect.