2. analog
  3. 1312058368

Graham Phantom Supreme?

Has anyone done a comparison between the Supreme and the mkII? Is it worth changing and expending the extra outlay?

The main revisions appear to be the bearing housing and an improved magneglide stabiliser (I think the internal wiring was up to a good standard already on the mkII)

There is a company called AudioMax Ltd (approved contractor?) which can perform upgrades from both Phantom I and Phantom II to the Supreme build.
Any experience of this conversion out there ?
Many thanks... :)
moonglum
wrm57
975 posts
 
Rockitman, are you using the outer ring on the Clearaudio table? If so, that might be one reason MusicalSurroundings recommended the 10-in. The 9-in. brings the anti-skate mechanism uncomfortably close to the ring. I have one on the full Innovation Wood and I just *barely* have clearance with my 9-in. Phantom II.
rockitman's avatar
rockitman
417 posts
 
Good Point Wrm57. The arm lift rest is quite close to the ring with my 10". I can't imagine life w/o the ring though. Nothing like flat record playback, not to mention the other bennies. I need to take closer look at the anti-skate clearence.
syntax's avatar
syntax
2,193 posts
 
Hello,

here are some lines in copy from Grahamengineering about that:

... we offer the longer wands for the sole reason that some turntabales with record rings (VPI, Clearaudio) require more length for the arm components to clear. And that's the only reason...

... In a word - don't worry about the long length; you're much better off with the standard 9" arm...

Hope this helps, and best wishes,
Bob Graham

I use mainly 9" Phantom IIs, has the advantage, that the alignment gig is calculated for it, too.
dertonarm
1,042 posts
 
Rockitman, Wrm57, the 10" arm wand was - as the 12" arm wand - Graham's reaction to market request. Indeed you will have a hard time mounting a 9" Phantom (or any other 9" pivot) when the platter diameter exceeds 320 mm or when using an outer ring on the platter. Whether Clearaudio, VPI in specific or others - the 10" is the way to go when using the outer ring anyway. But pay attention to the off-set.
rockitman's avatar
rockitman
417 posts
 
10-29-11: Dertonarm
Rockitman, Wrm57, the 10" arm wand was - as the 12" arm wand - Graham's reaction to market request. Indeed you will have a hard time mounting a 9" Phantom (or any other 9" pivot) when the platter diameter exceeds 320 mm or when using an outer ring on the platter. Whether Clearaudio, VPI in specific or others - the 10" is the way to go when using the outer ring anyway. But pay attention to the off-set.

so there is no advantage with longer arms ? I though longer arms had lower tracking error ? That's why the Gradenzza is 12" the Durand Telos is 12" ect. ? Help to understand...
More to discover