Vinyl reissues quality

Even supposedly virgin vinyl is not very high quality these days. I read an article about a new pressing operation in New York City. They acknowledge that even the best vinyl stock they can find is quite inferior in quality to stock available in the heyday of vinyl. What they do is "regrind" the vinyl into a powder before using it to minimize the impact of impurities.

Experiencing the same; I stick with LPs pressed at RTI and Pallas in Germany; quality seems higher. Re done Dire Straits are good examples of what new pressings should sound like.

If one reads about the LP record production process from start to end, you end up amazed that any LP sounds acceptable. There are just a lot of points in the process for quality to deteriorate.

A lacquer coated metal master is cut, which is electroplated to form a negative, which in turn is used to make a new all metal mother, which then is electroplated again to make the negative stamper plates.

Impurities in the plating chemicals, dust, or sloppy handling at any stage can cause noise in the stamped record.

Stampers can also be used past their prime. Stampers also do not typically fail instantaneously, so LPs made toward the end of the stamper's life will not be quite as pristine as those made at the start even if stampers are replaced on schedule.

And, as others noted, the quality of vinyl is also an issue. There is good quality vinyl available, but like any other business, some companies will put quality control second to cost factors.

I usually buy almost all of the new vinyl rock/pop/female vocalist reissues. I guess I have been lucky because I just don't have any complaints. Mine have sounded wonderful and quiet.

I agree that the RTI and Pallas pressed copies are fantastic. The (3) new Dire Straits reissues are indeed marvelous.

One thing I do to minimize the surface noise is that I always clean my new albums on a RCM prior to listening to them. Do you do this? If not, you might want to start, as I find it helps quite a bit.

Overall though, I agree with Mofimadness actually.
I have not had very many issues with the reissues.

I've had a few, but not too many. And admittedly, probably a higher percentage now (say 5% or so), have had surface noise, (specifically ticks and pops), than in the "good 'ole days", (when it was just one or two percent). But then again, perhaps the mid-fi equipment that I had back then did not allow me notice the surface noise nearly as much.

My two cents worth.