No phono input on Jadis but want to buy tunrtable

Thought you got a table off ii Bei... In that case, I would find a cart to go with your arm and phono stage and concentrate on just spinning tunes with the AR XA. It's an all-manual table, and I am sure there are people who can help you set it up. If you find that you are fine with the effort to deal with the LPs and the manual process of set up, cleaning LPs, cueing, lifting at record end, flipping, re-cueing, sitting down, getting back up because you left your beer next to the TT, then sitting down again to listen to the next 20-25min side, then you should be fine and then you can decide to go further. I bet for most people starting back into analog, the biggest investment is that of changing their listening and preparation habits. I expect that if you decide you don't want to continue down the road of vinyl, you could sell off the table and phono you bought and not lose more than a decent dinner out.

LOL... well, the quality of the sound will determine if I will continue down that path or not. From what I read from all the spinners, I am pretty sure that I will love the sound. I am very curious to see if it will be an improvement over what I am listening to now, but if it is, I imagine that I will take the plunge a lot deeper as time goes by.

Any suggestions on a nice cartridge to match up with my Hageman Concert2 ?

What are the important values to watch for in a stage? I am trying to make an intelligent decision on purchasing a cartridge for my system and I sure could use a brief explanation to jump start my search.

Here are the specs on the Hageman Cornet2 Stage:

Specifications
Gain +44dB
Input Impedance 47k ohm
Output Impedance 1k ohm
RIAA Response +/-1dB from 25Hz to 25kHz
Bandwidth 15Hz to 30kHz
Distortion 0.02% @1kHz
SNR 72dB ref 5mV A-weighted
Overload 250mV @1kHz
Phase Normal
Size 7.25" x 11.65" (PCB)
Weight 7 lbs
Power 35W
Input Voltage 100V, 110V, 120V, 200V, 220V, 240V
Tubes 12AX7 (ECC83) x 2, 12AU7 (ECC82) x 1, 5Y3 x 1

Is this enough to tell if I should be looking for a MC or MM cart and anything else that might be especially noteworthy?

Lokks like you should stick to a MM cartridge or possibly a high output MC.

I agree with Tom_hankins about output. Rather than buying another gadget (head amp or step-up transformer) in order to be able to use a low-output MC cart, I'd go for a higher output cart. Having never tried a HOMC of any kind (to my recollection) on any table in my system, I could not suggest an either/or. While I might be hesitant to buy a used cart in some cases, in this case, you might get more bang for buck in buying a used cart (and hoping the seller isn't selling you a beat up jalopy of a cart). If you buy a new one for a few hundred USD and decide it isn't for you, given your acquisitions so far, that is where the loss would come if you sold everything. If you like vinyl, then you can upgrade. In the meantime, just enjoy the tunes.

There are several threads in the archives where some great MM carts are discussed. Some of them are expensive, some less so. One thread I recently re-read is here. Another is here. Both are excellent threads with a fair bit of accumulated experience and knowledge about how arms and carts work and work together. You should also dig around the archives here and in the Vinyl Asylum. You could also ask the question over at the Vinyl Asylum stating what you are starting with and your goals in acquiring a cart.