Opinion about this cantilever


Recently purchased a (gently) used Accuphase cartridge.  It looks clean and not worn... however, there does seem to be an alignment issue.   Thoughts?  
Is this a candidate for a rebuild?

image 1

Image 2

Image 3

Image 4

 

kjim

Listen to it, above all. That slight deviation from straight may be harmless. What does the stylus look like, at higher magnification? If it’s asymmetrically worn, then for sure do send it off.

I wish I could look at it for you under my Wild-HerrBrugg M5 microscope.  I would need to look straight down at the point of the stylus under greater magnification to see what the wear pattern is going down each side of the diamond.  Without being able to see that, you are flying blind.  My microscope is in FL and I am in NH until after Thanksgiving so I can't help you.  SoundSmith is still upset from re-location, therefore, your best option is VAS, which is just as good anyway.  If you are in FL and can wait, I do this for free.  I am not in business, have nothing to sell, just do it because.  

What ever you choose to do with the miss alignment of the cantilever just remember if you choose to install the cart and play it, align the cantilever with the grid and not the body. Enjoy the music

Peter_S. I used this: USB microscope. Could be better but for $20 it was perfect. 

Thanks everyone for the input. I will probably send it to Steven L. Just to check for crud if nothing else.