??? Which XLR Interconnect ???

@freediver what are you using now?

If you really must use long interconnects I would say try Bluejeans XLRs. In my opinion cheap cables built by some of these manufacturers you listed want to  pretend to be what they’re not. This results in some sort of unwelcome coloration of sound almost always. Bluejeans don’t pretend to be anything special. They will give you honest view into what your components are doing without dirtying up the presentation with some emphasis in one region or another. 
No they’re not the best cables out there. But they’re not going to mess anything up for you. If anything use them to get a baseline. Long interconnects is not the best idea though. Hope there’s a good reason for this. 

I concur with others, start out low cost until you have a feel for your new system, then spend some cash to get the ones that complement it best. It is a pretty critical piece of the system.

Personally, I decided on the material for my XLR interconnects before the brand.  Here are your options:

1. OFC Copper

2. OCC Copper

3. OFC Copper coated with Silver

4. OFC Silver

5. OCC Silver

6.  I heard there is OCC Copper with OCC silver coating, but, I am not sure.  Same for OFC with OCC silver coating. 

I have a full separate component system with monoblocks and I changed all my interconnects all at the same time, from OFC Copper to OCC Copper.  I immediately felt that this was a step up in sound and really made a difference.  Note:  they were not all the same brand, and I bought them all used on Audiomart/Audiogon/ebay... 

My vote would be for Kubala-Sosna. They have many different models with a wide range of prices.

@hjdca ive found that once I tried  cables using OCC copper the silver coated OFC cables did not perform as well. The sound was distorted.

Even  regular silver did not have the same dynamic performance as OCC copper.

OCC silver was by far the best conductor.

Regards