Would This Amp Be Worth The Cost?


Opinions please.
Amp for Sonus Faber Olympica III speakers.

Looking at this amp  Musical Fidelity M8s-500S Power Amplifier
Info https://www.musicalfidelity.com/products/m8series/m8-500s

Replace my Classe Sigma Amp2.
Info

AMP2

FREQUENCY RESPONSE:

10 Hz – 20 kHz, -1dB into 4 Ohms

OUTPUT POWER:

200W rms into 8 Ohms, 400W rms into 4 Ohms

HARMONIC DISTORTION:

<0.018% @ 1 kHz Balanced Input

INTERMODULATION DISTORTION:

>80 dB below Fundamental into 8 Ohms Balanced

SIGNAL TO NOISE RATIO:

-100 dB at Peak Output into 8 Ohms (AES17)

Would there be improvement? Worth the cost? 
Thanks
greywolf
Interesting.  I have some lamp cords I have been selling.  OP, I am glad you are happy with your system.
When the source material is the same and the speakers are the same and the room is the same, it seems differences in what kit lies between them have a negligible effect when the listening is blind. Examples abound:

http://matrixhifi.com/contenedor_ppec_eng.htm

It’s no use saying “but I can tell”. All these guys thought that too.

You should thank these dedicated audiophile colleagues because they are saving you from spending money on what doesn’t matter (cables, amps, racks, crystals, etc) so you can spend it instead on what does matter (source material, speakers, and your room). 

You should thank these dedicated audiophile colleagues because they are saving you from spending money on what doesn’t matter (cables, amps, racks, crystals, etc) so you can spend it instead on what does matter (source material, speakers, and your room).

He should thank you for providing a very good example of what NOT to do. Ignoring quality amplification, cables, source components etc. is a sure fire way to end up with a mediocre system. If that is his goal I implore him to follow your advice.
You post your blind listening test result that show that anything other than source material, speakers and room make any audible difference.  I’ll keep posting examples of where people who were utterly convinced they could tell differences in amps, cables, racks, etc find out that they just can’t.