A Better Bluesound AC Cable?


Has anybody replaced the stock C7 IEC (Figure 8) cable on their Bluesound Node 2?
Audioquest makes an affordable 2-prong cable...
https://www.audioquest.com/cables/ac-power-cables/2-pole/nrg-1-5

And a C7 to 3-prong...
https://www.amazon.com/dp/B07DLDNDC2/ref=sspa_dk_detail_2?psc=1&smid=A17IVE6SUAZA2P

Or does it make more sense to use a C7 to standard adapter ?


128x128lowrider57
Hi, I tried the nordost purpleflare, and liked it. Sound was a bit more detailed than standard.
Later on I upgraded the rest of the system to audioquest and used a audioquest z2. Sound was a little deeper and darker. I liked it better. Changes were very small.
Just picked up a new or refurbish Vault 2 directly from Bluesound and I am very pleased to say least. 

I tried it directly to my preamp with Wywires Silver IC’s and it didn’t sound too bad then with a Nordost Silver Shadow to the DAC in my CD player and pretty noticeable difference for the better.

I should have my parts today from VH Audio to build my own which I went with Furutech FI-11M and FI-8NC7, then using VH Audio Shielded Twisted Pair AC cable which I will tie the shield back at the wall. I might build the cable so I can float the shield on the fly as well. After I get some hours I will report my findings.

Also ordered a Supra CAT 8 Ethernet cable which I’ll have in a few days as well.
Stock cord on my Node 2i plugged in to a Shunyata Hydra Triton conditioner.  Absolutely amazing performance from the internal dac.  Node plugged into a wall outlet keeps the magic out.
Granted, the Hydra Triton is expensive, but I already owned it.  A better PC might help to some extent.
New PC built and up and running. With no time on the new cable it’s already better. Stock cable has a little bit of an edge on top but not too hot but it’s there. Comparing CD’s I’ve ripped to the drive sound much closer to the CD. Need to give it much more time to burn in but very promising. Took half hour to build and $160. All parts from VH Audio.

Whether or not going into a power conditioner I’d say it’s worth changing out the PC. I went with a shielded cable, and on a digital component that alone makes sense over the stock PC. Better plugs will help as well.  Definitely sounds much better.
Anyone looking to build a power cable for any equipment with the C7 plug, the 12 AWG shielded pair Cryo from VH Audio is a outstanding cable. I just built this PC with only twenty four hours or so on it and I’m floored how good it is on my Bluesound Vault II.

https://www.vhaudio.com/images/shieldedtwistedpairbulk.jpg

Used the following plugs.

https://www.vhaudio.com/images/fi-11mg.jpg

https://www.vhaudio.com/images/furutech-fi-8n.jpg

Tied the shield  to the wall plug ground pin. Really loving this Vault and through my DAC it sounds very good. Probably my best audio purchase in awhile. Having lots of fun with it.