2. cables
  3. 139271-100109

recommendation for speaker wire to soften the highs if possible

Hello,
I need help. My problem is my system sounds harsh on the highs to me. Not extremely bad, but enough that I need to fix it. My system consists of Ryan 610's, oppo Sonica Dac, and a Belles 150a hotrod amp. Speaker wires being used are old monster cable from the 90's. I also have monster cable rca. I mostly stream through Tidal. My question is can I make the desired effect by switching cables or should I add  a tube amp or pre amp. My budget on the wire would be around 300.00
Thanks in advance for any suggestions
128x128gunmetalzin
gunmetalzin's avatar
gunmetalzin OP
6 posts
 
Thanks for the useful and quick response.
Inna I don't know if the cables are causing it and  high frequencies distortions the better term. I also know cables are a hot topic and I'm not looking to go down that rabbit hole.I just wanted some advice or experience from the members on certain cables that might help and be a cheaper route if I go for new cables. 
kalali's avatar
kalali
1,977 posts
 
It sounds like you're using your Oppo as a preamp which could contribute to the sound you hear. Also, depending on the length of your speaker wires - assuming ~8' and not longer, you may have better luck looking for "warmer" interconnects to tweak your sound. Just as an aside, I think putting a tube preamp between the Oppo and your Belles will transform your system for better.
wlutke
713 posts
 
gunmetalzin,

I had the early nineties Monster "Powerline 2" speaker cable for some time.  If that's what you have it's Nasty Stuff.  I suggest the Acoustic Zen Satori I use (of course).  It can be easily found used at your price point.  It clears out the glare and edge in a huge way.  There is a slight lower-mid / upper-bass bump that can be pleasing in the right (not overly warm) system.  
twoleftears's avatar
twoleftears
5,313 posts
 
It's unlikely to be the Ryan or the Belles.  Very unlikely.  Obviously, principal suspicion falls on the Monster, though the situation might not be ameliorated by the Oppo.  I think you should rewire the whole loom, interconnects and speaker.  Make sure you stick with all copper (+ if relevant, gold plating).  Some good recommendations here; you might look too at Wireworld and Audio Sensibility.
Post removed 
More to discover