I'm considering used Vandersteen Quatro

Vandy 2CE speakers are incredible sounding bargains…seem to always be available used with stands for peanuts. 

I ran the Quatro's for over 4 years in a 15' x 11.25' x 8' room and they worked really well once I spent the considerable time to dial them in for room placement and then adjust the bass equilizer for finishing touches.

They worked very well with an EAR 890 that pushes 70W class A tube power with a lot of oomph.  I liked them even better with a 100W VAC Phi 200 driving them.  I actually used my Primaluna Dialogue One for a short interim fill, and they sounded nice and musical, but were not powerful enough for loud rock, big orchestra, electronica, etc.  It is a EL34 based amp with 35W, and I would bet that KT88 might work a smidge better.  More power was better, though.

I would seriously think of a more powerful amp if you like concert levels of louder music.

@jetson - I think your wife will probably have an issue. The Vandersteens are bigger and will look more physically imposing than the Totems. My wife doesn't care too much because the stereo is down in the basement. Is there no other room you can use? If you've got the land, perhaps you can build a listening shed out back. (I believe Michael Lavorgna of AudioStream has a barn on his property for this purpose.)

In any case, my room is about 22' x 13.6' x 8' and I have the speakers firing down the long wall and about 24.25" from the back wall - measured from 'acoustic center' with the distance calculated using Vandersteen's 'odd dimensions' method. It's what sounds best so far to my ears while also accounting for room layout limitations.

You might get just as good (or better) results with a two-way standmount speaker and subwoofer.

John at Audio Connection, and Richard at Vandersteen.  Both ...the very best. 

the odd dimension placement makes any speaker sound better and you can always use the meter and a test disc to tweak for room nodes at listener position. The Vandy manual is a tour de force for proper setup...