What could cause this amp to fail?


Hi Everyone,
Apologies if this is the wrong forum for this question. I just got into serious speakers (been into headphones most of my life). I picked up a pair of Thiel CS1.5’s that have blown me away. Anyways, I also bought a used Perreaux EX-120 (circa 1994 MOSFET Class AB 100wpc) Integrated amp on ebay for pretty cheap (seller had no feedback and I decided to take a chance) which is the subject of this question.

For the first few days after plugging it in it sounded great: warm, smooth, powerful until on around the fifth day, I noticed the sound cut from the amp and what sounded like a click. I powered it down and let it rest. The next day I heard the same thing but it started to happen more and more frequently. It would start about a minute after starting to play music and then quickly increase to the point where it would be clicking and cutting out multiple times per second (it doesn’t happen if no signal is running through). There was also a noticeable clicking coming from within the amp itself. The problem now starts happening immediately after putting signal through it and doesn’t stop.

I took it to a local audio repair who thought it was a relay issue but was unable to fix it after several tries. He referred me to another repair shop who has now told me that 8 Mosfets in the amp are blown and the input selector has ’aged out’. To repair it would cost about $450 dollars as he would have to replace many components in the amp and that it would end up as a just a power amp since the selector is a custom component that Perreaux doesn’t sell anymore.

I’m trying to get my money back from the seller, but he’s pretty much refusing saying that this is impossible and suggesting that I must have overloaded it since it worked when he sent it out. One thing to note is that I have carpet (not deep, quite short) and the binding posts on the Thiels are at the very bottom where I imagine it’s possible that the carpet could come into contact with the connectors. I have 2 other amplifiers (an entry level Cambridge Integrated and a B&K receiver which is a MOSFET design) and neither have had this issue.

My question is: could static electricity or contact between the carpet and the binding posts/cable connectors cause the amp to fail? If so, how come it took 4-5 days? If not, what is the possibility that it is my fault?
joezuu
@OP,
I would call Ralph (Atmasphere) directly. 
If anyone is qualified to repair an amp, it is him.
Bob
How long have you had it? If its less than 30
days Ebay usually sides with the buyer if you 
open a case and say it doesn't work.
Sorry about your issues with the Perreaux. I still have a 3150 that I bought in the late 90's, I hold onto it as a spare....just in case kina thing. By and large they are built like tanks and rarely need repair, although with age comes failures in caps and such as they have a fixed life span.

They do tend to use some odd parts as I have an On/Off switch that has long given up the ghost, I managed to get it on and now shut the amp down by killing the power in my conditioner.

If I were to start using it for any period I would be definately looking at a re-cap before putting it back into service...always liked their products...

Good Luck

PS, You should email Perreaux, they were very helpful when I was looking to replace the switch even though they no longer had them, they gave me several alternatives that they had been recommending.

Couldn't hurt..
A clicking sound to me is a relay not latching. It’s possible that an overload or dc offset protection circuit has a bad holding/charging capacitor that feeds a transistor holding a speaker protection relay closed.