2. speakers
  3. 161880-9815

Vandersteen, Audio Note, and Resistance

I have an Audio Note Kit Four, which is a 10w tube amplifier. It has 3 speaker posts per channel - one black, one 4 ohm red, and one 8 ohm red. 

I am trying to connect to Vandersteen 1c speakers, which claim to be 6.8 ohm (+/- 2 ohms).

My question simply is: which binding posts do I use, the 4 ohm or the 8 ohm? I am getting conflicting advice between my friends and youtube.
ubersujith
6 responses Add your response
ubersujith OP
9 posts
 
Thanks all. I tried both taps, I think the 8ohm one sounded a tad better.

And surprisingly, amp was not terribly "disappointing" as ozzy62 and I thought. I read on Vandee's website that Richard thinks that 1c should be fine with 15wpc from tubes.

tomic601's avatar
tomic601
12,792 posts
 
The model 1 are 90 dB, try both taps. Like all Vandersteen they are engineered to present a relatively easy load.

enjoy the music :-)
ozzy62's avatar
ozzy62
2,837 posts
 
I think you are going to be disappointed with 10 watts driving vandersteens no matter what tap you use.

Oz
Post removed 
ubersujith OP
9 posts
 
Just saw some more youtube vids. Apparently, I need to be concerned  about over-heating the output transformer if I use the 8 ohm posts.
erik_squires
15,682 posts
 
Try either. :)

It's not going to hurt you, but you may hear one is really better than the other.

Pay particular attention to the mid-bass and treble.
Log in to respond
More to discover
80x80
Arion Audio Athena
80x80
Falcon Acoustics IMF 200 Speakers
80x80
ATC SCM200PT