I too am having a problem with my 47f. When I push start the arm begins to move over but after moving about an inch it returns to the rest. Could this be the same as another post where it involves some photo electric cells on a board under the tonearm?
Denon DP-47F arm return problem? Help needed
I bought a used Denon DP-47F a full automatic, micro-processor controlled, direct drive turntable yesterday.
The arm does not return to the rest after playing a side and the repeat function switch does not work. They seem related as they take place at the end of an LP. It seems to be a voltage adjustment, but I can't figure it out in the service manual.
Can anyone help me with this problem. It would be nice if I can adjust it myself, but I would like a repair service recommendation too.
Service manual manual is available on Vinyl Engine:
http://www.vinylengine.com/library/denon/dp-47f.shtml
Thank everyone so much, as this is a really nice TT.
The arm does not return to the rest after playing a side and the repeat function switch does not work. They seem related as they take place at the end of an LP. It seems to be a voltage adjustment, but I can't figure it out in the service manual.
Can anyone help me with this problem. It would be nice if I can adjust it myself, but I would like a repair service recommendation too.
Service manual manual is available on Vinyl Engine:
http://www.vinylengine.com/library/denon/dp-47f.shtml
Thank everyone so much, as this is a really nice TT.