20amp v 15amp

I'm the furthest thing from an engineer so layman's terms would be appreciated.  A friend of a friend has an Audioquest Niagara 5000 he's looking to move quickly.  The 5000 requires a 20amp power cord, which is fine; I'm happy picking one up.  My outlet is only rated for 15amps.  My question is, will I only really benefit if I replace the 15amp wall outlet with a 20amp wall outlet?


If  the wall outlet is 15-amp 125V then you'll need either a 20 amp to 15 amp plug adapter or a one foot 20/15 power cord. Each are less than 10 dollars. But if you know how to replace a receptacle, then install a combo 15/20 amp 250V receptacle. Fits perfectly in the same box.

Not really, no. 

For many manufacturers the 15A and 20A outlets are identical except for the plastic face plate. They literally use the same brass behind the plastic, down to the T shaped connectors.

Fact is 15A outlets have to live with the possibility of being on a 20A circuit, so they are built with that in mind.

It's a weirdness of the NEC that they expect you to run 20A circuits to multiple 15A outlets.

Get a good 12 Gauge cable, no matter the connector on the end.

a good read: 15 AMP VS 20 AMP OUTLET

I think you should also consider the max wattage draw of your audio system.

up to 1800 watts for a 15 A


up to 2400 watts for a 20 A 


investing in a good power conditioner can help with overall system performance. I've explained it quite a few times already.

The main issue is safety and not overheating the power wires because the powered devices are drawing too many amps, which is a definite fire hazard.  I doubt many amplifiers draw 20A all by themselves (i.e., I can't think of any with a 20A fuse).  However, I suspect some amplifiers use a 20A cord because the  manufacturer has considered that some users may connect the amplifier to a circuit with other stuff on it - IOW, because of the high'ish current draw of the amplifier, there is a greater chance that the total amperage of devices on the circuit may exceed 15A.  Side benefits are that the amplifier's power cord will have a better connector and heavier wire.

Your easiest solution is to make sure the amplifier is plugged into a 20A outlet powered by a 20A circuit using at least 12awg wire and a 20A breaker.  Do not replace the 15A outlet with a 20A outlet unless you confirm the entire circuit is rated for 20A.  The reason for this is to prevent someone from plugging a device that draws 20A into a 15A circuit and overheating the wire in the circuit.

Post removed