power conditioning vs. power regeneration?

Hi Bob,

I think that what might be misleading you is the phrase "modulate the output from the power supply," which I too have seen said in various contexts.

In a typical design, the internal power supply of an audio power amp is essentially not in the signal path. The power supply converts the incoming ac into dc voltages, which in a good design are then heavily filtered, and then those dc voltages in turn power the amplifier circuits.

The same goes for a power regenerator. Its internal power supply converts the ac to various dc voltages, which are filtered and then used to power its 60Hz power amplifier.

The internal power supplies in both cases, therefore, provide isolation between the power amplifier circuits and noise or other garbage which may be present on the incoming ac. If the amplifier's power supply did its job to 100% perfection, totally isolating noise on the ac line from the audio signal path, there would be no benefit to connecting it to either a conditioner or a regenerator. But nothing is perfect, and in some systems with some ac power sources the conditioner or regenerator can supplement the rejection provided by the supply in the audio component.

Hope that is helpful.

Regards,
-- Al

Thank you gentlemen for such a clear set of answers!
Indeed trial is the ultimate decider but i was curious if one was more suited to doing a better 'all around' job, such as surge protection, fluctuation etc.
To me it seems that the regenerator introduces a 'pure' sinewave which is unfettered from possible filtering excesses which may only help in some areas while causing harm in others!

Best,

Jake

Yes, in principle a power regenerator should do the best job. However, a good one, with sufficient output capability to power an amplifier and other components that may draw considerable current, will cost considerable $, and also be substantial in size and weight. The leading example that I know of is the PS Audio Power Plant Premier, which costs $2200.

And even for that unit you can find comments here from some people who found it to do more harm than good. I have no idea why that may have been so, assuming the current draw of their system on high volume peaks does not approach the regenerator's maximum capability, but like a lot of things in audio there are effects that are inexplicable.

Regards,
-- Al