Can a single terminal speaker be bi-amped?


Just acquired a second Hitachi HMA 7500, legendary amp from 70s, revamped by Approved Audio, and want to use both amps with my Kef LS50s. I would double up the speaker cables. What damage could I cause?
springbok10
Seconding Mechans' comment, when the two amplifiers are paralleled, to the extent that each of them is "trying" to put out a signal that is not absolutely identical to the signal that the other amp is "trying" to put out they will each be forced to drive that difference into a load impedance corresponding to the output impedance of the other amp. In the case of most solid state amps that output impedance will be very close to zero ohms.

It looks like the HMA-7500 can be bridged. However in this case I would not recommend doing that either, because the impedance of the LS50 gets as low as 4 ohms at some frequencies in the bass region, where a lot of energy is often required. In bridged mode the amp will "see" a load impedance equal to 1/2 of the speaker's impedance, meaning as little as 2 ohms at some frequencies. The HMA-7500 is not rated to drive less than 8 ohms in bridged mode.

Regards,
-- Al
Doubling the load onto vintage amps isn't healthy as well.
The only good solution I see is to get biwired speaker.
Give it a try and let us know how it works out. You could just run the speaker wire from one amp to the terminals of the other amp and turn them on at exactly the same time. Good science experiment :)