2. amps-preamps
  3. 1285350105

tube choice for Audible Illusions L1

I have a Audible Illusions L1, and it has humming noise on the left channel. I suspect it is the tube. Also, I would like to smooth the sound a bit more. The recommended and current tube I have is 6h23neb. However, I have someone previously recommends Svetlana 6n1p. I would like to try it out, but it says on the AI FAQ that "6NIP tubes should not be substituted as they require additional filament current and their use will compromise performance."
What does compromise performance means? Does it mean the tube life will decrease? But it won't do any damage on the unit, am I correct?

Also, from the tube store, I can't specify the brand. Is it important to order a specific brand?

Besides the 6h23neb and 6n1p, is there other suggestion that will help smooth out the sound, or make it less harsh?

Thanks.
gte357s
gte357s OP
281 posts
 
Thanks for the advice. I don't think it is because of the interconnect though. I got the noise since the first day I got this preamp, then I upgrade the interconnect, and the noise is still there. Maybe some capacitor are old? Inside, there is a sticker says it is checked in 96. So, it is a 14 years unit. Is it about time to have a service and replace some capacitor?

I did some more listening, the Main 2 out seems work for me. It remains musical with good sound stage, and the harshness or glare is improved.
jefgerard
8 posts
 
I have had L-1 for about 7 years. One day the tubes went bad it made a harsh static kind of sound. I replaced the tubes and all was fine. On the Audible Illusions site they recommend tubes to use and not use. I had a set of brand new Svetlana tubes which I used. I then went on ebay and got some cheap mullards. When I replaced the Svetlana tubes with the Mullard tubes there was a noticeable increase in fullness and base. Also I notice that the highs were less fatiging
gte357s OP
281 posts
 
i finally got the Electro-Harmonix-6922 and listened for an hour, so far, I like it. it doesn't have the glare as in my previous 6h23neb. I also feel the detail and sound stage are improved
gte357s OP
281 posts
 
Need help again. I just got the new EH 6922 tube over the weekend, but today, I found out it has very loud hissing sound ... is that the tube is done?
audioconnection
1,270 posts
 
Greetings GTE 357
Trying to save money is sometimes tough.
I would get the serial number so we can have AI get you a low noise gain matched set for that circuit.
This is what I have found to work best. Johnnyr
More to discover