2. misc-audio
  3. 1371940337

How Good Is A Marble Slab at Deadening Vibration

I have a marbles slab that is approx. 42" X 16X 2". A left over insert from a coffee table. I would like to lay it on top of a plant stand table that is 50" X 18X 30" The slab weigh about 70 lbs. II think I have enough space laterally to position a Rega turntable, a Bel Canto line stage, and Rega Apollo CD player and a pair of Red Dragon monoblocks, that could easily be stack vertically if necessary.(Also could place them on the bottom shelf which has a slight V-shaped dip ...probably a run off channel. This would save me three feet of speaker cable on both channels is placed near the bottom)

The plant stand is made of wood and has fairly massive "L-shaped" legs. The table weight is about 40 pounds.

My thinking is that a marble slab should provide excellent isolation from vibration. The only drawback is the left side of table will only be a foot from the right speaker. So I would start the progression of components from right to left to increase the distance to the speaker in question. Would like opinions from members about the pros/cons of this set-up. Thanks, Jim
sunnyjim
jp1208
502 posts
 
How about 3/4" acrylic? Supposedly very good for draining vibration.
sunnyjim OP
927 posts
 
TO BW: The cork mat sounds simple enough to make..... Unfortunately, I decided to go ahead and try the marble slab before I read any of the posts, so therefore my concern about lifting it again. Surely, a two man job. I will let you know if I decide to install the cork.
bombaywalla's avatar
bombaywalla
1,958 posts
 
06-28-13: Sunnyjim
TO BW: The cork mat sounds simple enough to make..... Unfortunately, I decided to go ahead and try the marble slab before I read any of the posts, so therefore my concern about lifting it again. Surely, a two man job. I will let you know if I decide to install the cork.
fair enough. The only thing I can say here is that do NOT make a judgement until you have tried the marble slab with the cork sheet under it. Thanks.
hevac1
812 posts
 
Great I think, the heavier the better. I used Marble under my tube amps when I had them as I felt they looked better in the room. I now use granite slabs under all of my equipment. All the source equipment is in a closet but the amps now.
If you do not use some kind of rubber or a mix of cork and rubber most any stone item will ring.
You can buy rubber and cork squares from Mapleshade for way too much money IMO, or you can purchase them on Amazon. They are larger but you can cut them down. They are rated for 50 lbs. per square inch so take all the weight in account. You can use any extras for under equipment.
BTW I sold the Marble with the amps.
sunnyjim OP
927 posts
 
To Hevacl, does the sale of rubber and cork squares appear in the audio accessories section on Amazon, and who makes them, or is it DIY?? I do not want to elevate the slab more than one half inch off of the surface of the wooden table. Thanks, Jim
More to discover