If you are trying to fit the wire into the eyelet on the L-Pad, you can do either of three things.
1) Slightly enlarge the eyelet in the terminal to accept all of the strands.
2) Solder the wire to the terminal without slipping it through the eyelet.
3) Do as Bob said and reduce the strand count on the wire. The small reduction in gauge or conductor size at this point shouldn't make any noticeable difference. Sean
>
1) Slightly enlarge the eyelet in the terminal to accept all of the strands.
2) Solder the wire to the terminal without slipping it through the eyelet.
3) Do as Bob said and reduce the strand count on the wire. The small reduction in gauge or conductor size at this point shouldn't make any noticeable difference. Sean
>