2. tech-talk
  3. 1218474065

Top resistors

Many threads with opinions on boutique coupling capacitors, but very little consolidated information on the sonics of resistors. Anyone care to share their thoughts on the attributes of their favorite brands & types for specific tube and SS applications? How much of a difference does a good resistor make?

My interest in the topic increased after recently installing the latest Texas Components nude Vishay TX2575 in several SS and tube phono & LS components. This was a proverbial "Ah-ha" moment-- a stray resistor dropped into signal path here or there, surprising with an improvement that equalled or surpassed the impact of a switch to a top coupling cap like V-Cap or Mundorf.
dgarretson
clabe
101 posts
 
Mr Dgarretson!
I´ve changed to Duelund (big ones) graphite resistor and Mundorf Silver/Oil cap on my Merlin MX in tweeter section.
Sound is smoother but yet detailed. Hovland I find edgy/harsch. I would very much like to swap the whole crossover to Duelund caps/resistors, but it would break my budget.

I would like to change input resistors (47k) on my Jadis DPMC phono pre. Don´t know if 47k loading is of one or more resistors, no circuit diagram. It´s just to test, maybe it´s not worth it. I use MC cartridge of 0.6 mV.
Any experience?
Thanks and enjoy music!
rodman99999
5,976 posts
 
Mr D- You are correct! A transparent, non-inductive resistor like the Bulk Foil Vishays(or Caddock Ultra- Precision Film) will make an audible improvement vitually anywhere it's installed in the signal path.
dgarretson OP
2,586 posts
 
Mr C,
Thanks for info on VSM-MX application; I have been on the fence about modding stock xover. I am considering Claritycap MR or Duelund for that job. BTW, TX2575 in signal path in BBAM increases transparency vs. stock MK132. Best to look inside Jadis and check values of resistors closest to phono input. Values are not always intuitive. They do make a difference.
theaudiotweak
2,769 posts
 
I ordered my Starsound amps 5yrs ago with the naked Vishay resistors. The upgrade in price was well worth the increase in resolution and reduction in noise floor compared to the same amp with the standard resistor pack. Part of my decision for the nude was based on my previous upgrade to Vishay bulk metal film resistors configured in a bridge mode to replace those that were stock in my Dunlavy SC4's. That was a shocking difference to both my pocket book and to my ears. Well worth the expense. Tom
clabe
101 posts
 
Mr Dgarretson
Thanks for advice about BBAM, how many resistors need to be changed (no diagram). Nice system BTW.
Noticed you´ve changed to bigger batteries, how does it affect the sound (find originals to small).
I will check/measure resistors in DPMC.
More to discover