Speakercbl runs through my doorway and too thick

Remove your baseboard, drill holes inside the walls to basement and through the baseboard. When no longer needed fill holes with insta foam and replace baseboard. Your walls should be about 2 1/2"+ with sheetrock & baseboard.

How handy are you? The width of your door molding plus drywall is about 1" (or more if you have plaster walls), which means you can offset the cable about one inch toward the kitchen – which is right where the threshold sits. To do this, I would carefully remove the door molding (which you will reuse), remove enough of the drywall/plaster behind where the door molding goes so that you will be able to route the cable into where the threshold sits. Now, remove the existing threshold and cut out (skill saw + chisel/hammer – or, preferably a router or wood grinder) an area about two-thirds the depth of your cables thickness and just slightly wider than the width of the cable. Then, route your cable into the new “channel.” Replace the door molding. Now, you will install a custom wood threshold (you can buy one or just buy a piece of hardwood that matches your wood floors). You will want to cut a dado on the underside of the new threshold (the depth of which will be the remaining one-third of the cable width – and the width of which will be slightly wider than the width of the cable). Now, cut the threshold to fit, and place it over the cable. This will look professional, and it will provide a safe environment (for you and your cable).

Thank you all for your responses. I am not sure if I will be keeping these cables, so maybe I can just find a cable that isn't so big. If not I will look into some of the other alternatives.
Thanks again