Will an RCM make the Rice Krispies go away?


The two step RRL cleaning process and my Nitty Gritty make a big improvement in lowering record noise and enhancing clarity. However, there are some records that still have varying degrees of "snap, crackle and pop"! Is this residual dirt, a damaged record, a manufacturing defect? I'm thinking about investing in a Loricraft but am wondering if this instrument will cure the cereal syndrome.

A corresponding issue is the greater degree of noise on initial tracks. I notice the closer the record is to the end, the less noise. Does anyone else find this unusual?

As always, your insight is most appreciated.
rballdude
So it seems Vinyl-Zyme is in my future, based on all the positive comments. I use a Herron VTPH-1 phono amp, with a Kuzma Stabi table and Kuzma Stogi arm along with a Benz Glider. I was planning on upgrading the Glider until I replaced my old Yamamura interconnects with H.T. Magic and now have all the detail and soundstage I could ever want. Bass is far tighter, as well. I'm also using an Audible Illusions M 3a pre-amp and AP Scorpio speakers. All possible connections have been treated with ESST.

Sure appreciate all the suggestions. Thanks,

Mike
Questions and call for clarifications:

When you say steam-clean, what kind of device or process do you mean? I have a Scunci Steamer. If I sprayed an LP with record cleaning solution, swished it around with a pad or brush, and then, instead of rinsing or suctioning, blasted it with the steamer, it should really melt and blow out the grunge, but would the heat damage the record?

Concerning enzyme cleaner, would it have to be Vinyl-Zyme, or would an enzyme cleaner such as you get at a pet store work as well?

I have a lot of used records that have been pleasant surprises. I just played a couple records I found in 99-cent bins that are dead quiet and play like new. OTOH, there's that used MoFi pressing of SuperTramp's Crime of the Century that I just got off eBay. It makes constant noise throughout both sides.

Mike - while not intending to side track this thread, how do you like your AP Scorpios?

On topic, my Loricraft regimen (similar with Doug's, I believe) is Premier, VinylZyme, RRL wash - in that order. The VinylZyme definitely helps.

Tim
Hi Rballdude,

Great comments from Doug, Ralph (of course), and others. Yes, I didn't emphasize enough that ringing can come from many sources - both mechanical and electrical.

I take it that the A-I is only serving a line stage function - being fed by the Herron? I only know the Heron by its good reputation. Perhaps other Herron owners can comment about its unique strengths and weaknesses (nothing is perfect).

Benz cartridges in general tend to track more quietly than most ... getting quieter as you work your way up the food chain.

Assuming the stylus isn't trashed, I'd look into a thorough cleaning regimen - including the Mr. Clean Magic Eraser. Properly adjusted, your system is at a level where even a couple of plays without cleaning will be audible to a greater or lesser extent. Now, I'm not looking at this being a silver bullet, but it certainly won't hurt to cover your bases here.

Cheers,
Thom @ Galibier
As for the enzyme cleaner, try Walker Audio Prelude or Audio Intelligent. I agree w/others that a vacuum cleaning machine (e.g. VPI or Loricraft) is 95% required. If you don't have one, plenty of elbow grease will be needed.

If you are looking at cartridges, IME the stylus on the ZYX line will allow you to enjoy your beat up LPs with less noise than most of the competition. ZYX's other attributes are many, but that's for another thread.

As Thom noted, Magic Eraser for stylus cleaning(read the archives) is a superior method, and a critical part of my routine for LP playback.
Don't worry, the old LPs have plenty of music in them. Cheers,
Spencer