Subwoofers: Do you turn them off when you are done for the day?


It just occurred to me last night as I was putting various amps into standby mode before going to bed that I only turn off my subwoofers when I am going to be away from home for a few days or more. (I disconnect all my components from the wall in those cases.)  

All my amps are solid state and their respective manufacturers have all advised to switch them to standby if you are not listening to them, even if you plan to listen again in a few hours.  Why do I not do that with the subwoofers (all RELs: one Class D, 2 Class A/B)?  Seems like one should. (And I did last night.)

What do you all do?

kirkwallace

@curiousjim , that is like my amps, less than 0.5W for the Rowland and less than 1W for each of the Gato PWR-222 monoblocks.  The designer for each recommends standby mode when you are not using them; only need to fully turn them off/disconnect them from AC mains when you’re going to be away for days/weeks (and during electrical storms).  

According to a post by REL on a REL Facebook group, the 115V T/9x (and maybe the 220V too?) draws 9.6 watts when on but idle.  (The manual and website do not give that stat.). 9.6 Watts doesn’t sound too bad.

@kirkwallace 

I have PS Audio BHK 300 mono blocks and they are warm all the time!  I just looked them up and they draw @175 watts each on standby! The BHK preamp is a lot less. I’m guessing I’m around 500 watts when not in use.  I listen 6-7 days a week or I’d probably turn off the amps at the very least.  
With the temps hitting 90°+ here, maybe I’ll turn the amps tonight and see what things sound like in the morning.  I know after even a long weekend, I can hear the difference.

I have the Ref 31's which draw about 50W when on but idle.  Not sure I can tell a material SQ difference between always on or standby but I choose to leave them on based on the very specific recommendation in the manual for service life.  At a 10W draw there would be no question for me.

My subs are powered actively by an external class A/B studio amp, which is turned off by the end of a day's use. The same goes for the internal class A/B amps/electronic crossovers in my active speakers. A friend of mine recommends leaving on all amps during weekends, the rationale being that he finds there's a sonic benefit with his setup when they've been left on for +24 hours (he uses the same studio amp, but a whole 3 of them top to bottom outboard actively). There might well be, but I've always been more comfortable turning off the amps overnight. However I do leave on my DAC 24/7 during weekends, while on the other days it's put on standby overnight (I also prefer to turn it off completely for 5-10 minutes every week or two). My voltage regulator, DSP and network isolator are left on 24/7 all the time. 

No.

My JL Audio subs go into sleep mode automatically after the music stops.

I unplug everything when there is a thunderstorm.