I want to upgrade my Turntable to something heavier

@elliottbnewcombjr Once I resolved the floor noise, I went ahead and made the call. The Hana ML won't be in stock until midweek, and they will set it up and ship it to me. Which gives me time to get a larger platform in. The VPI is wider than my Pro-ject, 

I ended up with the VPI Prime Turntable & JMW-10 3D Tonearm"

@alahankbear 

Solid choice. Not seeing any mention of your phonostage, this is where consideration in maximizing your retirement rig.

ANY cartridge won't perform in it's best light without one.

As @audphile1 mentions,  living with VPI unipivot  can be challenging initally, but since you're getting it shipped ready to go, should be smooth sailing. 

Might be worth learning to setup later via online videos for maintenance adjustments to keep it performing as expected. 

Highly recommend, if your dealer hasn't already

Counter Intuitive for VPI tone arms | Soundsmith

Enjoy it!👍

Between the massive plinth, superplatter, double motor pod, base platform, and the welded steel floor stand, my VPI HR-X is probably 300+ lbs all-in.   Lol not the most helpful post perhaps, just saying it’s out there, once you figure out what “it” is….best of luck.   

@tablejockey I am using the Phono Stage built into PS Audio Stellar Strata MK2, at least for now. And yes, I want to learn to maintain my TT. I just don't want to learn and break something to start out. Another Phono Stage may come sometime. 

@alahankbear 

The built in phono in the Strata mk2 has 57db gain and 100ohm impedance. 
Gain’s fine but 100ohm impedance could be a bit low for the ML. To break it in I was loading it at a 1000ohm then dropped it down to 400ohm after the break in. 100 will probably be a bit too polite sounding but that highly depends on the rest of the system and your listening preference. 

I wouldn’t worry about it initially but for the ML to give you the proper ROI, a good phono stage is a must. And down the road good phono cables between VPI and phono stage