1. Home
  2. amps-preamps
  3. 196594-105283

Looking for help - Classe Omega Monoblock - Blinking Red light

Have been using Classe Omega Monoblocks for a while. Few months ago, one of the amps started blinking red on power up (even when disconnected from the speakers). Any one experienced similar issue with these amps and can suggest troubleshooting or . Or anyone who can repair them in the NE/Tri-state (NJ/PA/DE) region??

ravig
ketchup
710 posts
 

I think that means protection mode is triggered (I can't remember if my CA-200 would flash red or green when protection mode was triggered). Swap the input cables left to right and see if the problem follows the cables. Your preamp might be passing DC in one channel.

ravig OP
1 posts
 

Thanks for the advice. If I recall, the amp blinks red even when no input or speaker is connected. Will try again to try my luck. 

More to discover