What innovative, unconventional cartridge designs can you recommend?

richardbrand 

... A stylus can be subjected to side loads above 10,000-G ...

Unless you can show the math on that, I’ll assume it’s just a typo.

There are those that claim a stylus at typical VTF exerts many tons of pressure at its tip. That isn’t true, either.

@antinn @cleeds 

Thanks for the correction.  I claim a typo, or at least a brain fade!  1000-G will do but it is still a lot of acceleration, and it is driven by side-wall pressure from the groove acting on the effective inertia of the cantilever, etc, seen at the stylus.

A ton on its own is not a measure of pressure until you add the area the force is acting on, eg tons per square inch.  The contact area is determined by the stylus shape and the deformation of the vinyl it is pressing into.  The actual tip does not contact the groove at all.

It seems that line contact styli distribute the downforce over a greater area than conical styli, which are a poor fit to the groove

@elliottbnewcombjr 

Thanks for the need for a SUT in addition to my MC input.  Puts me off the ART-1000X a fair bit, especially as I find out more about the unique features of the DS Audio series 3 range.

Conventional cartridges have to do physical 'work' as they generate electricity from the movement of the stylus.

DS Audio cartridges use an external power source, and the stylus does no work to generate electricity.  Instead electricity is generated when photons hit two light receptors.  The photons stream from two powered light-emitting diodes, one for each channel. In between the emitters and the receptors is a 'shade' made of extremely light beryllium, attached just above the stylus. 

The output of each receptor is proportional to the amount of shade not in the way.  Unlike conventional cartridges, the output varies with the position of the stylus.  Electromagnetic cartridges generate signals proportional to the transverse velocities of the stylus.  At the limit of excursion, DS Audio generates maximum output, conventional cartridges none.  That is why conventional phono stages won't process DS Audio output correctly.

The signal produced by the powered cartridges is huge, so signal to noise can be far lower.  I think I am sold, if only I had the money!

@richardbrand,

There is a stylus wear test being performed by Ray Parkhurst over at the Vinyl-Engine with some very interesting results; it's a 30-page thread, but starting at this page will give some insight - SWS3: Stylus Wear Study 3 - Page 24- Vinyl Engine.

The whole concept of the stylus bottoming is now being analyzed with the details showing that records are cut differently which can impact when the stylus bottoms-out.  There is a lot to digest.   

The Soundsmith strain gauge cartridge. It eliminates the RIAA- equalized phono stage.