Best products for baffle material s ?


Looking for the "best" combination of materials. Building new boxes for my B&W CM1 bookshelfs as I can feel vibration on the baffle and sides, with classical music, quartet, at even very modest volume. These are very small 2 ways - so I can afford to go "all-out" on the boxes. High mass, inert, shaped baffle to minimize diffraction, interior design to break up waves. I'm considering only products that can be "woodworked". More detail later. Thanks.
ptss
Corian, Aluminium, carbon fiber all see use in high end speakers. My Magico S5's use some kind of composite material. I should enquire and ask what it is.
Rodman,

The width and length of the baffle is an integral part of designing a crossover for a speaker. I'd make sure that especially the tweeter sees exactly the same boundaries as in the original design, if the same x-over is to be reused.

I'd agree that rounding over the edges on the front baffle probably will have minimal effect. However don't go making a 7 inch wide baffle 12 inches wide.

Best of luck

Peter
Of course, Peter. Somehow- I thought you had already covered
that elsewhere and that the OP had replied, in the
affirmative.
BTW, Ptss: You mentioned doing the cabinets in black.
Corian has a color called, "Nocturne" that can be
polished to resemble a Piano Black finish. Would look
sharp, with no visible seams and a 1/2" radius, on all the
corners. Personally; I'd dovetail the sides, top and bottom
and install the front and back with dado joints. Talk
about a solid/non resonant cabinet! I can send you a sample
piece, if you want to get an idea of how rigid, dense and
workable it is.
The width of baflle influences more the frequency response of the driver, or its spread?