2. home-theater
  3. 182764-179433

My Home Theatre Room Challenges - Is It Worth It To Upgrade Speakers

I have a very nice 2-channel stereo room where I love to listen to music by myself.  I am happy with the equipment and set-up in this room (at least for now).

Our family room (on the other side of our home) serves as our Home Theatre room and my wife and I watch a movie in this room together almost every night.  We recently upgraded to a Sony 83" A90J television and we love the picture quality.  

I consider sound quality to be just as important as picture quality when it comes to watching a good movie.  The 5.1.2 sound equipment in this room currently features:

  • Yamaha RX-1080 Surround Processor
  • Paradigm Prestige 15 Front Speakers on stands 
  • Martin Logan ESL Center Channel
  • Polk PSW1000 Powered Subwoofer
  • Paradigm Millenia 1 Overhead Speakers
  • Polk In Wall Rear Speakers
  • Room size = 20' wide X 18' deep (no rear wall)
  • Ceiling Height = 20' tall

The room has two big challenges:

  • WAF is critical - this is our family room, having front speakers that sit 4' out into the room is not going to happen
  • there are two couches that sit directly between the Front L&R speakers and our two primary listening chairs.

I would love to make a big and impactful improvement in sound quality in this room. I am currently considering replacing my two front main speakers (Paradigm Bookshelf 2-way speakers with 6" drivers) with full-sized speakers.  I am considering speakers, like perhaps a nice used pair of B&W 803 D2's, with the intent to dramatically improve base and be able to better fill the large room with sound.

Question:  Will the two couches block the sound improvement that I am trying to achieve?  (Right now my bookshelf speakers sit on stands which allows the soundwaves to not be blocked by my couches.)   Does this upgrade of front speakers in my large room seem like a logical first step?  I would love to hear from someone else who possible made some similar changes.

Thanks!

hikerneil
hikerneil OP
20 posts
 

One more question:  I am zeroing in on adding the REL T7x sub to my system.  This sub has the ability to be wired with both High Level wiring (to speaker outputs) and also the LFE channel.

Should I add this sub to my Center Channel outputs, or the Front Right / Left outputs?  It seems like if I add the High Level wiring to my Center Channel that I would capture deeper voices etc on the center channel, while if I added it to my Front Left Right's I would hear it more on musical tracks.  Is that a simple way to look at it?

Since I only use this room for Movies and TV I am leaning toward adding it to my Center Channel.  In either case I will also hook up the LFE as well to take advantage of high impact sounds while watching movies.

Advice?

kota1
2,706 posts
 

You have to try both to see what you prefer, if you add subs see the tips for sub placement Ihave posted in my virtual system page.

soix
8,655 posts
 

Not sure why you’d pick this Rel over the SVS SB1000 Pro for HT. The Rel has a 200W amp and goes down to 30Hz -6dB while the SVS has a 325W amp and goes down to 20Hz -3dB. Both are about the same size and have high-level and LFE inputs, but the SVS also offers integration software and is $400-$500 cheaper depending on finish. Plus, SVS offers excellent customer service and offers a truly risk-free, 45-day trial including shipping both ways. I suppose if this was for music you could make an argument for the Rel, but for HT the SVS would seem to be a better choice given its more powerful amp and ability to go so much lower in bass. Lastly, for $50 more than the price of the Rel you could get TWO SB1000 Pros! At that point you could consider selling your Polk sub that also only goes down to 30Hz to offset some some of the cost of the SVS subs, and you’d now have two matched subs with integration software to make your life easier. Just a thought.

kota1
2,706 posts
 

two subs is better for SMOOTH bass

erik_squires
15,662 posts
 

Hi OP

 

Don't complicate your subwoofer setup.  Use the LFE output and let the receiver or processor handle everything.  It's going to do a better job than anything you can do via speaker level inputs.

Best,

 

Erik

More to discover